Read Sharp MX-FNX10 (serv.man38) Technical Bulletin online
19. Attach the joint metal plate, 2 clips, and 2 screws removed in the procedures 14 and 15.
(Make sure not to drop the clips using long-nose pliers and so on.)
20. Check phase deviation of the semicircular gear sensor which is in the gripper unit on the rear side.
(1) Please confirm that the semicircular side of the semicircular gear faces toward the tray side.
(2) Confirm if the center of the 2 slits of the semicircular gear is at the center of the sensor.
(Confirm if the slits and the side of the sensor are parallel.)
Please adjust according to the items 21 - 22 if the phase deviates.
(2) Confirm if the center of the 2 slits of the semicircular gear is at the center of the sensor.
(Confirm if the slits and the side of the sensor are parallel.)
Please adjust according to the items 21 - 22 if the phase deviates.
21. Remove the clip indicated by the circle in the picture below.
(Please use long-nose pliers and so on when you remove the clip so that you will not drop it.)
Sharp Electronics (UK) Ltd., Technical Services Group
CCE-621
Click on the first or last page to see other MX-FNX10 (serv.man38) service manuals if exist.