Read Sharp MX-FN27 Service Manual online
MX-FN27 N, MX-PN14 OPERATIONAL DESCRIPTION 6 – 13
(2)
Staple-Free Staple Unit
The clinch arm moves down to clinch when the cam driven by the Clinch motor (FNM9) rotates once. The wavy upper teeth of the clinch arm is
pressed against the lower teeth to crimp the paper together.
pressed against the lower teeth to crimp the paper together.
The cam's home position is detected by the Clinch home position sensor (FNPS15).
If the Clinch home position sensor (FNPS15) is off, the finisher controller PCB runs the Clinch motor (FNM9) until the Clinch home position sensor
(FNPS15) turns on and resets the cam to its initial state.
(FNPS15) turns on and resets the cam to its initial state.
If an error occurs in the staple-free staple unit, a jam code is displayed on the host machine's operation panel, and the operation stops. The limited
function message of the staple-free stapling is shown on the host machine's operation panel, at the same time.
function message of the staple-free stapling is shown on the host machine's operation panel, at the same time.
When a jam occurs again, a trouble code is also sent to the host machine.
– Number of sheets that can be clinched
The number of sheets that can be stapled exceeds the upper limit of the number of sheets that can be stapled, select whether the operatio is contin-
ued or canceled after the paper is fed into the tray.
ued or canceled after the paper is fed into the tray.
When the operation is continued, 5 sheets are delivered in a stack without stapling and the 6th sheet is delivered by itself. And, the second stapling
papers also delivered by itself.
papers also delivered by itself.
When the operation is canceled, 5 sheets are delivered in a stack without stapling and operation is finished.
Item
Specifications
Remarks
Stapling capacity
55 to 64 g/m2: 5 sheets or less
More than 64 to 81.4 g/m2: 4 sheets or less
More than 81.4 to 105 g/m2: 3 sheets
More than 64 to 81.4 g/m2: 4 sheets or less
More than 81.4 to 105 g/m2: 3 sheets
- Stapling a mix of same width is only available.
- Stapling a mix of different widths is not possible.
- Stapling a mix of different widths is not possible.
Clinch home position sensor (FNPS15)
Clinch motor drive
detection sensor (FNPS13)
Clinch motor (FNM9)
Front Alignment Plate
Rear Alignment
Plate
Assist Guide
Clinch Arm
Clinch Arm
Cam
Lower Teeth
Clinch home position sensor (FNPS15)
Clinch motor (FNM9)
Upper Teeth
Click on the first or last page to see other MX-FN27 service manuals if exist.