Read Sharp MX-B201D (serv.man8) Service Manual online
MX-FX12 INSTALLATION PROCEDURE 1 - 3
NOTE: For installation of the rear cabinet, follow the procedures
shown in the figure below.
(7) Peel off the dummy key sheet.
Open the RSPF or OC.
Peel the edge of the dummy key sheet using a tool such as a
retractable knife, and then peel off the entire key sheet.
retractable knife, and then peel off the entire key sheet.
(8) Remove the dummy keyboard.
Unscrew the screw, and remove the dummy keyboard with a tool
like a pillar as shown below. (Save the screw.)
like a pillar as shown below. (Save the screw.)
(9) Attach the FAX keyboard.
1) Remove the tape which is fixing the harness to the operation
panel.
2) Connect the copier cable to the FAX keyboard. Note that the
cable should be folded as shown below and placed under the
keyboard.
keyboard.
3) Place the FAX keyboard and secure it using the screw
removed earlier.
4) Affix the key sheet to the FAX keyboard.
(10) Paste the label on the rear cabinet of the copier.
Paste the FCC or A-Tick label on the position shown in the illustra-
tion.
tion.
This procedure is correspondence only in North America (FCC)
and Australia (A-Tick).
and Australia (A-Tick).
7
2
1
6
5
4
3
In order to manifest the compliance with FCC Part 68 and ICES-03.
it is required to provide the machine with the FCC Registration
Number (USA), Ringer Equivalence (USA) and Ringer Equivalence
(Canada).
After installing the FAX expansion kit in the machine, please put the
registration label, packed with the kit, on the prescribed location.
it is required to provide the machine with the FCC Registration
Number (USA), Ringer Equivalence (USA) and Ringer Equivalence
(Canada).
After installing the FAX expansion kit in the machine, please put the
registration label, packed with the kit, on the prescribed location.
2
3
4
Putting standard
Putting
standard
standard
FCC or A-Tick Label
FCC or A-Tick Label
Click on the first or last page to see other MX-B201D (serv.man8) service manuals if exist.