Read Sharp MX-6201N / MX-7001N (serv.man41) Service Manual online
MX-7001N DRIVE SECTION Q – 23
(1) Tandem drive unit
1)
Remove the rear cabinet and the rear cabinet lower. (Refer to
the "[A] EXTERNAL OUTFIT".)
the "[A] EXTERNAL OUTFIT".)
2)
Remove the screws (A), and open the control box (B).
3)
Remove the screws (C), and remove the flywheel (D).
* When installing, check to confirm that has not come in con-
* When installing, check to confirm that has not come in con-
tact with the harness etc.
4)
Disconnect the connector (E). Remove the screws (F). Disen-
gage the pawl (G), and remove the duct (H).
gage the pawl (G), and remove the duct (H).
5)
Remove the resin ring (I), and remove the pulley sheet (J), the
belt (K), the pulley (L), and the parallel pin (M).
belt (K), the pulley (L), and the parallel pin (M).
6)
Remove the resin ring (N), and remove the pulley sheet (O),
the belt (P), the pulley (Q), and the parallel pin (R).
the belt (P), the pulley (Q), and the parallel pin (R).
7)
Remove the screws (S), and remove the support plate (T).
Unit
1
Tandem drive unit
1
B
B
A
A
C
D
C
G
F
H
E
I
J
K
L
M
Q
R
N
O
P
S
S
T
Click on the first or last page to see other MX-6201N / MX-7001N (serv.man41) service manuals if exist.