MX-6201N, MX-7001N (serv.man37). TRANSFER SECTION - Sharp Copying Equipment Service Manual (repair manual). Page 10

MX-7001N  TRANSFER SECTION  M – 10

2)

Remove the screws (A) and remove the plate (B), and remove
the secondary drive idle gear (C). Remove the bearing (D) and
the belt (E). Remove the polyslider (F), the pulley (G), the
polyslider (H), the bearing (I), and the parallel pin (J). Remove
the spring (K) and the plate (L).

3)

Remove the screws (M), and remove the frame (N).

4)

Remove the frame (O) and the bearing (P), and remove the
secondary belt follower roller (Q) and bearing (R).

5)

Remove the secondary transfer belt (S).

1)

Remove the secondary transfer unit. (Refer to the "(1) Second-
ary transfer unit".)

2)

Remove the secondary transfer belt. (Refer to the "a. Second-
ary transfer idle gear, secondary belt follower roller, secondary
transfer belt".)

3)

Disenage the pawl (A), and remove the bearing (B) on the front
side, the bearing (C), and the spring (D). Remove the secon-
rary transfer roller (E), and remove the bearing (F) and the
bearing (G).

1

Secondary transfer 
unit

d

Secondary transfer roller

✕ ▲

1

Secondary transfer 
unit

e

Secondary belt drive roller

✕ {