Read Sharp MX-6201N / MX-7001N (serv.man37) Service Manual online
MX-7001N TRANSFER SECTION M – 5
3)
Remove the screws (C), and remove the paper guide (D).
4)
Remove the screw (E), and disengage the pawl (F), and
remove the guide rail (G).
remove the guide rail (G).
5)
Remove the screw (H), and remove the guide (I).
* When installing, check that the shaft (J) is in the cut-out por-
* When installing, check that the shaft (J) is in the cut-out por-
tion (K) of the guide.
6)
Remove the screws (L), and slide the plates (M). Remove the
fixing bearing (N).
fixing bearing (N).
7)
Fold the transfer frame cleaner unit side (O), and remove the
primary transfer belt (P).
* When working, front side is made downward to prevent
primary transfer belt (P).
* When working, front side is made downward to prevent
damage of the primary transfer belt (P). When removing,
pinch the belt upper edge (rear side) (Q), be sure to don't
touch the surface.
pinch the belt upper edge (rear side) (Q), be sure to don't
touch the surface.
* Install so that the lot number (R) side of the belt inside is
front side.
* Apply starting powder
a)
Apply the Kynar powder (UKOG-0123FCZZ) to whole of
belt surface evenly.
belt surface evenly.
b)
Rub the Kynar that applied to the belt into the belt gen-
tly. (Cover the whole surface.)
tly. (Cover the whole surface.)
C
D
C
E
G
F
H
I
J
K
M
M
L
L
N
L
P
O
Q
1-a
R
Click on the first or last page to see other MX-6201N / MX-7001N (serv.man37) service manuals if exist.