MX-6201N, MX-7001N (serv.man37). TRANSFER SECTION - Sharp Copying Equipment Service Manual (repair manual). Page 13

MX-7001N  TRANSFER SECTION  M – 13

4)

Disenage the pawl (D). Remove the PTC cleaner B (E), and
remove the PTC cleaner (F).
* When installing, check that the charger wire (G) is posi-

tioned to center of the cleaner pad (H).

* When installing the PTC cleaner B (E), be sure to check that

the pawl (D) and the pawl (I) of the PTC cleaner (F) is
engaged.

* When removing or installing, be careful that the charger wire

(G) hang up the lower side (J) of the PTC cleaner (F).

1)

Remove the paper dust removal cleaner. (Refer to the “[G]
PAPER TRANSPORT SECTION”.)

2)

Remove the PTC unit. (Refer to the "(1) PTC unit".)

3)

Remove the PTC cleaner B and PTC cleaner. (Refer to the “a.
PTC cleaner B, PTC cleaner”.)

4)

Loosen the screw (A) within the range to hold the plate.
Remove the round terminal (C) from the pawl (B). Remove the
spring (E) from the pawl (D). Remove the charger wire (F).
Remove the spring (E) form the round terminal (G).
* When installing, hold the round terminal (C). Don't touch the

wire directly.

* When installing, be careful to dirt of the wire and don't put oil

etc., and be sure to prevent the wire bending or twisting.

1)

Release the lock (A), and open the right door unit (B).

1

PTC unit

c

Charger wire

✕ ▲

1

Secondary transfer 
separating drive unit

a

Secondary transfer 
separation motor

M -14

b

Secondary transfer 
separation drive sensor

M -15

1

Secondary transfer drive unit