Read Sharp MX-6201N / MX-7001N (serv.man27) Service Manual online
MX-7001N DSPF SECTION C – 24
(5) Transport roller 3 (drive)
1)
Remove the front cabinet and the rear cabinet. (Refer to the
"A. Exterior section".)
"A. Exterior section".)
2)
Remove the paper feed unit. (Refer to the "B. Paper feed sec-
tion".)
tion".)
3)
Remove the DSPF No.1 resist roller brake clutch and remove
the DSPF No.1 resist roller clutch. (Refer to the "C. Upper
transport section".)
the DSPF No.1 resist roller clutch. (Refer to the "C. Upper
transport section".)
4)
Remove the drive unit. (Refer to the "G. Drive section".)
5)
Remove the resin E-ring (A), and remove the No.1 resist roller
(idle) (B).
(idle) (B).
6)
Remove the screws (C). Lift the paper feed rotation tray (D),
and remove the paper feed PG lower (E).
and remove the paper feed PG lower (E).
7)
Disconnect the connector (F). Remove the screws (G), and
remove the control PWB unit (H).
remove the control PWB unit (H).
8)
Loosen the screw (I), and loosen the belt (J) tension. Tighten
the screw (I). Remove the belt (J).
the screw (I). Remove the belt (J).
9)
Remove the resin E-ring (K) and the bearing (L). Remove the
transport roller 3 (drive) (M). Remove the E-ring (N), the pulley
(O), the spring pin (P), and the bearing (Q) from the transport
roller 3 (drive) (M).
transport roller 3 (drive) (M). Remove the E-ring (N), the pulley
(O), the spring pin (P), and the bearing (Q) from the transport
roller 3 (drive) (M).
Parts
Mainte
nance
j
Transport roller 3 (Drive)
{
j
B
A
C
C
C
D
E
H
F
F
F
F
G
G
I
J
M
K
L
P
Q
N
O
j
Click on the first or last page to see other MX-6201N / MX-7001N (serv.man27) service manuals if exist.