Read Sharp MX-6201N / MX-7001N (serv.man27) Service Manual online
MX-7001N DSPF SECTION C – 22
11) Disconnect the connector (X) and remove the screw (Y).
Remove the DSPF paper pass sensor 4 (Z).
12) Remove the DSPF No.2 resist roller brake clutch and the
DSPF No.2 resist roller clutch. (Refer to the "(2) DSPF No.2
resist roller brake clutch, DSPF No.2 resist roller clutch".)
resist roller brake clutch, DSPF No.2 resist roller clutch".)
13) Remove the DSPF cooling fan motor. (Refer to the "G. Drive
section".)
14) Remove the E-ring (a), the washer (b), the spring (c), the collar
(d), the polyslider (e), the bearing (f), and the bering (g).
15) Loosen the screw (h). Loosen the belt (i) tension. Tighten the
screw (h). Slide the No.2 resist roller (drive) (j). Remove the
pulley (k), the E-ring (l), the bearing (m), and the bearing (n).
Remove the No.2 resist roller (drive) (j).
pulley (k), the E-ring (l), the bearing (m), and the bearing (n).
Remove the No.2 resist roller (drive) (j).
(4) DSPF paper pass sensor 5, Transport roller 2
(Drive)
1)
Remove the front cabinet and the rear cabinet. (Refer to the
"A. Exterior section".)
"A. Exterior section".)
2)
Remove the OC mat. (Refer to the "H. Others”.)
3)
Loosen the screw (A), and lower the angle adjustment plate
(B). Open the DSPF unit (C).
(B). Open the DSPF unit (C).
4)
Remove the screws (D), and remove the lift-up PG (E).
Z
X
Y
f
c
a
b
f
g
d
e
j
h
i
m
m
n
k
l
g
Parts
Mainte
nance
h
DSPF paper pass sensor 5
–
i
Transport roller 2 (Drive)
{
i
h
C
A
A
B
D
D
E
Click on the first or last page to see other MX-6201N / MX-7001N (serv.man27) service manuals if exist.