Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man33) Peripheral online
MX-7000N MX-LCX3 3 – 12
<3>
Push the large capacity tray slowly into the original position.
Push the large capacity tray slowly into the original position.
Then make a copy again to check to insure that there is no more
shifet. Repeat this procedure as required.
shifet. Repeat this procedure as required.
(3) Mechanical adjustment-2
Since the regulation plates are adjusted when shipping, there is
basically no need to readjust. If, however, diagonal feed is poorly
operated, adjust the regulation plate width and the diagonal feed in
the following procedures:
basically no need to readjust. If, however, diagonal feed is poorly
operated, adjust the regulation plate width and the diagonal feed in
the following procedures:
a. Regulation plate width adjustment
1)
1)
Press the lock button on the front cabinet and lower the paper
feed base tray to the paper supply position. Pull out the large
capacity tray.
feed base tray to the paper supply position. Pull out the large
capacity tray.
2)
Set a sheet of paper on the paper feed base tray. Check that
the front regulation plate is at the marked center, and push it in
contact with the front regulation plate. Loosen the blue screws
of the rear regulation plate.
the front regulation plate is at the marked center, and push it in
contact with the front regulation plate. Loosen the blue screws
of the rear regulation plate.
3)
Use the mark of the rear regulation plate, and fix the blue
screws at the position so that the clearance between paper
and the rear regulation plate is evenly 1mm.
screws at the position so that the clearance between paper
and the rear regulation plate is evenly 1mm.
NOTE: The positions of the regulation plates are even to the right
and left marks.
1mm
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man33) service manuals if exist.