MX-5500N, MX-6200N, MX-7000N (serv.man19). MX-FNX3 4 MX-RBX2 MXPNX2A-D SERVICE MANUAL-Disassembly Assembly-2 - Sharp Copying Equipment Peripheral (repair manual). Page 6

MX-FNX4  DISASSEMBLY AND ASSEMBLY  6 – 45

f. Removal of grate-shaped upper guide
1) Move the tray [1] lower than the grate-shaped upper guide [2].

(For moving the tray, refer to "Removal of No. 1 tray")

2) Remove the five screws [3], and remove the grate-shaped

upper guide [2].

CAUTION: Note for installing or moving the tray

When moving down the tray, push up the shutter [1],
and release the latch [2] on the lower surface of the tray
to lower the tray.
When the latch is released, the tray will free-fall. Hold
the tray with your hand during the removal.

1) Remove the screw [1], and remove the metal plate [2] and the

slide guide [3]. If the grate-shaped upper guide has been
removed, there is no need to perform this procedure.

2)

Remove the screw [4], and remove the stopper [5].

3)

Remove the two screws [6], and open the harness holder [7] at
three positions, and disconnect the connector [8] at two posi-
tions.

4)

Insert your finger into the hole in the back of the No. 1 tray [9].
Push the tray lift motor gear [10] toward you to release the
clutch, and lift the No. 1 tray [9].

CAUTION: When the clutch of the tray lift motor gear is released, it

falls by its own weight. When releasing the clutch, there-
fore, hold the tray at the bottom in advance. When
installing it, take care not to twist the tray cable.

[3]

[2]

[1]

[2]

[1]

[1]

[3]

[2]

[5]

[4]

[7]

[8]

[6]

[6]

[9]

[10]