Read Sharp AR-PE3 (serv.man6) User Guide / Operation Manual online
29
System software
13.
If the Select Market Region screen is displayed, press the name of the region for the
Fiery X3e and then press OK.
Fiery X3e and then press OK.
This screen is displayed only if English was selected from the language selection screen.
14.
At the Setup screen, select Run Setup and press OK. Reenter the customer’s settings
from the Configuration page that you printed earlier.
from the Configuration page that you printed earlier.
Enter settings for Server, Network, and Printer Setup, in that order. Bypass the settings
not included on the Configuration page if it is more appropriate for the network
administrator to set them. For more information, see the User Software Installation Guide.
not included on the Configuration page if it is more appropriate for the network
administrator to set them. For more information, see the User Software Installation Guide.
15.
After all setup options are configured, select Exit Setup from the Setup screen and
press OK.
press OK.
The Fiery X3e reboots with the updated system software and setup options.
16.
Allow the Fiery X3e to reach Idle.
Installing system software over the parallel port
The System Software CD contains two files. The first file contains basic information
required for the Fiery X3e to boot. The second file contains all of the system software.
To install system software using the parallel port on the Fiery X3e, you need:
required for the Fiery X3e to boot. The second file contains all of the system software.
To install system software using the parallel port on the Fiery X3e, you need:
• IEEE 1284 parallel cable, short
One end of the parallel cable requires a male IEEE 1284-B (36-pin Centronics)
connector for connecting to the Fiery X3e.
connector for connecting to the Fiery X3e.
• A computer with Windows 98/Me
• A CD-ROM drive, built in or attached
• At least 600MB of disk space free
• Support for ECP mode on the parallel port
N
OTE
:
If you use a computer with Windows XP or Windows 2000, installing system
software over the parallel port may succeed, but if it fails or runs too slowly, install system
software over the network port instead (see “Installing system software over the network
port” on page 27).
software over the network port instead (see “Installing system software over the network
port” on page 27).
The computer must be configured so the parallel port mode in the BIOS is set to ECP.
When you access the computer BIOS to set the parallel port mode to ECP, you may
discover that ECP is the default mode, or you may discover that ECP mode is not
supported at all. If ECP is not supported, you can either install an add-in board (not
provided), use a different computer, or opt for a much slower installation using
Compatibility Mode.
When you access the computer BIOS to set the parallel port mode to ECP, you may
discover that ECP is the default mode, or you may discover that ECP mode is not
supported at all. If ECP is not supported, you can either install an add-in board (not
provided), use a different computer, or opt for a much slower installation using
Compatibility Mode.
In addition to accessing the BIOS, setting up the computer requires certain port and
printer settings in Windows 98/Me. Before you begin installing system software, follow
the procedure for setting up the computer.
printer settings in Windows 98/Me. Before you begin installing system software, follow
the procedure for setting up the computer.
Click on the first or last page to see other AR-PE3 (serv.man6) service manuals if exist.