Read Sharp AR-PE3 (serv.man6) User Guide / Operation Manual online
24
Verifying connection to the network
Verifying connection to the network
The Fiery X3e provides twisted pair connectivity to an Ethernet network. This section
describes how to connect the Fiery X3e to the network and print some test documents in
order to verify the connection. Category 3, category 4, or category 5 unshielded twisted
pair (UTP) network cable can be used for 10BaseT. Category 5 or later UTP cable can be
used for 100BaseTX. The network cable connects to the RJ-45 connector at the faceplate
of the Fiery X3e (see Figure N on page 24).
describes how to connect the Fiery X3e to the network and print some test documents in
order to verify the connection. Category 3, category 4, or category 5 unshielded twisted
pair (UTP) network cable can be used for 10BaseT. Category 5 or later UTP cable can be
used for 100BaseTX. The network cable connects to the RJ-45 connector at the faceplate
of the Fiery X3e (see Figure N on page 24).
F
IGURE
N
Fiery X3e external connectors at the faceplate
T
O
CONNECT
A
TWISTED
PAIR
CABLE
TO
THE
F
IERY
X3
E
1.
Shut down and power off the Fiery X3e, as described on page 6.
2.
Connect the network cable to the RJ-45 connector at the faceplate of the Fiery X3e.
3.
Configure Setup options.
It is the network administrator’s responsibility to configure Setup according to the
network and user environment. Default settings in Setup may be adequate although they
may not be optimal for the user’s environment. For Setup information, refer the network
administrator to the User Software Installation Guide.
network and user environment. Default settings in Setup may be adequate although they
may not be optimal for the user’s environment. For Setup information, refer the network
administrator to the User Software Installation Guide.
4.
After configuring Setup options, verify the network connection.
Once the network connection has been made and the Fiery X3e has the correct Setup
configuration and is Idle, the Fiery X3e should be available on the network.
configuration and is Idle, the Fiery X3e should be available on the network.
The network administrator should perform any additional network Setup, verify the
network connection, verify that the Fiery X3e appears in the list of printers, and print a
few test documents from a networked computer that will use the Fiery X3e. For more
information, see the User Software Installation Guide.
network connection, verify that the Fiery X3e appears in the list of printers, and print a
few test documents from a networked computer that will use the Fiery X3e. For more
information, see the User Software Installation Guide.
10/100BaseT connector (RJ-45)
for twisted pair Ethernet
Parallel port connector
10/100BaseT LED (amber)
Off = 10BaseT
On = 100BaseTX
On = 100BaseTX
Network activity LED (green)
Off = No activity
Blinks = Network activity
Blinks = Network activity
Faceplate
Click on the first or last page to see other AR-PE3 (serv.man6) service manuals if exist.