Read Sharp AR-PE2 (serv.man6) Service Manual online
4-9
4
Checking network connections
Printing to the Fiery AR-PE2
If the customer can print a Fiery AR-PE2 Test Page but cannot print a job from a
computer on the network, you may have to make a service call. However, first make sure
the network administrator has done the following:
computer on the network, you may have to make a service call. However, first make sure
the network administrator has done the following:
• Checked all components of the network including cables, connectors, terminators,
network adapter boards, and network drivers.
• Activated the network and used it to communicate with other printers.
• Checked the corrective actions listed in “Fiery AR-PE2 Error Messages” in the Job
Management Guide.
• Confirmed that the applicable network settings in Setup (such as AppleTalk zone, IP
address, Subnet mask, and Gateway address) match the settings used in the network.
When you make a service call, check the Fiery AR-PE2 faceplate at the side of the copier
to make sure that the appropriate network connection is in place.
to make sure that the appropriate network connection is in place.
Print quality problems are difficult to trace. Before you try to troubleshoot print quality
problems, print a Test Page to make sure that the copier does not need servicing or
adjusting. Also, make sure the correct paper is being used in the copier.
problems, print a Test Page to make sure that the copier does not need servicing or
adjusting. Also, make sure the correct paper is being used in the copier.
N
OTE
:
EPS file generation is not completely standardized among applications. Some users
may encounter problems while printing certain EPS files.
Click on the first or last page to see other AR-PE2 (serv.man6) service manuals if exist.