AR-M700 (serv.man26). Setting and adjustments - Sharp Copying Equipment Service Manual (repair manual). Page 34

: Feb. 9 2004

AR-M550/M620/M700  SETTING AND ADJUSTMENTS  7 - 34

1) Set the test chart (UKOG-0162FCZZ) on the original table so that it

aligns with the front frame. Then put four or five pieces of A3 (11" x
17") paper . 

2) Go through the modes specified in Simulation 46-12.

3) Select the adjustment item (FAX EXP. LEVEL) using the numeric

keypad. 

4) Press the Start key. 

5) Press the Start key (A copy is created.)

Check the print density. 

If the print density is not at an acceptable level, do the following
steps.

6) Enter the print adjustment value using the numeric keypad.

7) Press the P or Start key

This applies the adjustment value. 

Pressing the Start key starts print operation as well as applying the
adjustment value. 

8) Check the print density. 

Repeat steps 6 to 8 until an acceptable print density is obtained.

Note: Adjusting the Fax print density through this simulation changes

the print density settings for all Fax modes to the density level
applied by carrying out this simulation.
The Fax mode print density settings for individual Fax modes
adjusted through Simulations 46-13, -14, -15, -16 and -45 are
changed to the print density level applied by this simulation.

This adjustment is intended to the print mode for each Fax mode indi-
vidually. In manual mode, the print density setting for each print density
adjustment level (1 to 5) can be adjusted to a custom density level. 

1) Set the test chart (UKOG-0162FCZZ) on the original table so that it

aligns with the front frame. Then put four or five pieces of A3 (11" x
17") paper .

Select 0, and 
press [START] key.

Press [START] key, or 
press [CUSTOM SETTINGS] key.

Item

Set 

range

Default

0

TRAY SELECT

Paper feed tray selection

1

COPY START

Copy START (Default)

2

FAX EXP. LEVEL

FAX mode print density

0 - 99

50

00

SIMULATION 46-12

EXP.LEVEL SETUP FAX(AUTO SET). SELECT 0-2, AND PRESS 

START.

0.TRAY SELECT 

1

 1.COPY START

2.FAX EXP.LEVEL 

50

Press [CUSTOM SETTINGS] key. 

SIMULATION 46-12

EXP.LEVEL SETUP FAX(AUTO SET), INPUT VALUE 0-99, AND

PRESS START.

2.FAX EXP.LEVEL

50

1

Press [START] key.

Press [CUSTOM SETTINGS] key, 
or terminate copying.

SIMULATION 46-12

EXP.LEVEL SETUP FAX(AUTO SET). NOW PRINTING.

Select 1, and 
press [START] key.

Select other than 0 - 1, and 
press [START] key. 

SIMULATION 46-12

EXP.LEVEL SETUP FAX(AUTO SET).SELECT 1-6, AND PRESS

START.

(FEED TRAY)

 1.TRAY1 2.TRAY2 3.TRAY3 4.TRAY4

 5.BPT   6.LCC

00