AR-LC5 (serv.man3). AR-LC5 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 3

AR-LC5  UNPACKING AND INSTALLATION  3 - 2

2) Attach the mounting plates A and B.

<1> Attach the two upper mounting plates with the rubber portion

(

★

) down to the right side of the main unit using screws B

(two for each). (See the illustration below.)

<2> Attach the mounting plate to the lower right side of the

optional stand using two screws A.

<3> Remove the two screws that secure the LCC cover on the

right side of the main unit and then remove the LCC cover.

3)  Attach the connecting plate to the large capacity tray.

<1> Remove the two bottom plate securing stepped screws

attached to the large capacity tray.

<2> Insert the connecting plate with the marking surface up into

the lower part of the large capacity tray from the marking
side.

<3> Attach the connecting plate by inserting screw C into the hole

of marking "A" of the connecting plate.

4) Attach the large capacity tray to the main unit.

<1> Insert the connecting plate attached to the large capacity tray

to the mounting plate at the lower part of the optional stand
until the base is inserted.
At this time, lift the leading end of the connecting plate a little
to insert the plate easily.

<2> Gently detach the large capacity tray from the main unit and

check that the tray is locked.

<3> With the tray locked, attach the securing plate with two

screws D.

5) Adjust the height of the large capacity tray.

<1> Move the large capacity tray near the main unit.

<2> Adjust the height using the following procedure so that the rib

of the large capacity tray is aligned with the axis of mounting
plate A attached to the main unit viewing from the top.

Push the large capacity tray into the main unit.

<1> Loosen the two screws of the adjusting caster mounting plate

attached to the lower part of the large capacity tray.

<2> Turn the knob clockwise viewing from the top so that the rib is

aligned with the axis.

<3> After adjustment is complete, tighten the two screws of the adjust-

ing caster mounting plate and push the large capacity tray into the
main unit.

<1> Loosen the two screws of the adjusting caster mounting plate

attached to the lower part of the large capacity tray.

<2> Turn the knob counterclockwise viewing from the top so that the

rib is aligned with the axis.

<3> After adjustment is complete, tighten the two screws of the adjust-

ing caster mounting plate and push the large capacity tray into the
main unit.

Screws B

 Screws A

Screws

LCC cover

Upper
mounting
plate

Upper
mounting
plate

Mounting
plate

★

★

★

Upper
mounting
plate

Rubber
portion

Screw C

Connecting plate

Stepped
screws

Connecting plate

Mounting plate

Securing plate

Screws D

Axis

Rib

Rib

Axis

Screw

Knob

Rib

Axis

Screw

Knob