AR-LC5 (serv.man3). AR-LC5 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 4

AR-LC5  UNPACKING AND INSTALLATION  3 - 3

6) Connect the connector of the large capacity tray.

<1> Remove the screw from the power supply cover on the rear

side of the optional stand and then remove the power supply
cover.

<2> Cut out the portion of the power supply cover shown in the

illustration.

<3> Hang the two pawls of the power supply cover on the rear

cabinet and attach the cover with the screw.

7) Remove the paper feed table securing screw and the securing

material.

<1> Pull out the paper tray of the large capacity tray until it stops.

<2> Remove the paper feed table securing screw and the five

pieces of the securing material.

<3> Gently push the paper tray to its original position.

∗

If another peripheral device must be installed, carry out the following
steps at the end of the installation work.

Insert the power plug of the main unit to the outlet and turn on the main
switch.

8) Carry out the off center adjustment.

Since adjustment has been made at shipping, adjustment is nor-
mally not needed here. If the center should be, however, dis-
placed, carry out the following steps to adjust.

Make a copy. If the center of the copy is displaced as shown in Fig.
1 or Fig. 2, perform the following procedure.

Move the tray lock plate in direction A by the displaced length,
tighten the two screws at portion a and the eight screws at portions b
in this order, and make a copy again to check that the center is not
displaced.

Move the tray lock plate in direction B by the displaced length,
tighten the two screws at portion a and the eight screws at portions b
in this order, and make a copy again to check that the center is not
displaced.

Then, loosen the two screws at portion a that secure the tray lock
plate and the eight screws at portions b (on the right and left sides)
that secure the tray cover unit to the frame and adjust the off center
referring to the illustration below.

Power
supply cover

Screw

Cut-out portion

Power supply cover

Power
supply cover

Pawls

Screw

Paper feed table

Securing material

Paper feed table
securing screw

Securing material

Center line of paper

Center line of paper

Fig. 1

Fig. 2

Center line of image
 (first image)

Center line of image
 (first image)

Tray cover unit

Scale (in 1 mm increments)

Tray lock plate

Portion a