Read Sharp AR-F14 (serv.man3) Service Manual online
AR-F14/PN1 UNPACKING AND INSTALLATION 3-5
18) Install the stapler unit into the finisher.
<1>Remove the packing the tape (two pieces) from the locations
shown in the illustration.
<2>Open the finisher front cover and insert the stapler unit.
19) Attach the exit tray to the finisher.
<1>Hang the two pawls of the exit tray on the finisher.
<2>Use the four screws D to secure the exit tray.
<2>Use the four screws D to secure the exit tray.
At this time, check that the positioning dowel is securely
inserted.
20) Check and adjust the height of the finisher.
Bring the finisher close to the copier and check that the guide pin is
inserted smoothly into the connecting hole of the finisher.
If the guide pin should not be inserted smoothly, adjust as follows.
a. If the guide pin is deviated from the finisher connecting hole:
<1>Loosen the adjustment section securing screw on the rear side.
<2>Remove the cap with a flat-blade screwdriver or the like and use
<2>Remove the cap with a flat-blade screwdriver or the like and use
the height adjusting screw to adjust the position so that the guide
pin matches the center of the finisher connecting hole.
<3>Loosen the adjustment section securing screw on the front side.
<4>If the guide pin can be inserted smoothly, tighten the adjusting
section securing screws on the front side and the rear side and
attach the cap.
attach the cap.
b. If the guide pin matches the finisher connecting hole:
<1>Push the finisher into the copier.
Guide pin
[03]UNPACKINGANDINSTALLATION.fm 5 ページ ２００４年４月２７日 火曜日 午後７時４分
Click on the first or last page to see other AR-F14 (serv.man3) service manuals if exist.