Read Sharp AR-F14 (serv.man3) Service Manual online
AR-F14/PN1 UNPACKING AND INSTALLATION 3-4
•If the copier is equipped with a small stand and three paper drawers,
proceed to step16).
•If the copier is equipped with a large stand and two paper drawers or a
small stand and four paper drawers, you must change the height of the
finisher. In this case, be sure to perform step15) with the finisher placed
finisher. In this case, be sure to perform step15) with the finisher placed
on the packing box.
15) Change the height of the finisher
(if the copier is equipped with a large stand and two paper drawers or
a small stand and four paper drawers)
<1>Remove the screw and then remove the cover.
<1>Remove the screw and then remove the cover.
<2>Remove the four screws that secure the fittings of the front side
and rear side respectively and then remove the two fittings.
<3>Extend the finisher stand, reattach the two fittings that have been
removed in <2>, and secure them with four screws for each.
<4>Reattach the cover and secure it with the screw.
16) Connect the finisher to the stand / paper drawers.
<1>Remove the cover from the finisher stand.
<2>Insert the connecting plate into the connecting plate mounting
<2>Insert the connecting plate into the connecting plate mounting
section and attach it with two screws B.
<3>Reattach the cover to its original position.
<4>Attach the ground plate as shown in the illustration and secure it
with screw B.
17) Secure the connecting plate to the stand / paper drawers.
Secure the finisher connecting plate to the stand / paper drawers
with two screws B (M4 x 6).
[03]UNPACKINGANDINSTALLATION.fm 4 ページ ２００４年４月２７日 火曜日 午後７時４分
Click on the first or last page to see other AR-F14 (serv.man3) service manuals if exist.