Read Sharp AR-F14 (serv.man3) Service Manual online
AR-F14/PN1 UNPACKING AND INSTALLATION 3-2
4) Remove the right cabinet.
<1>Open the bypass tray.
<2>Open the right door.
<3>Remove the two screws and then remove the right cabinet.
5) Remove the copier second exit unit.
<1>Remove the connector of the copier second exit unit from the
copier.
<2>Remove the four screws and then remove the copier second exit
unit.
6) Attach the supplied F14 second exit unit.
<1>Arrange the connector harness of the supplied F14 second exit
unit as shown in the illustration.
<2>Attach the F14 second exit unit to the copier and secure it with
the four screws.
At this time, take care so that the harness is not caught between
the copier and the second exit unit.
<3>Connect the connector to the copier.
7) Attach the rear cabinet.
<1>Reattach the rear cabinet to its original position and secure it
with the four screws.
<2>Reattach the maintenance cover to its original position and
secure it with the screw.
<3>Reattach the right cabinet that has been removed in step4) to its
original position and secure it with the two screws.
<4>Close the right door and the bypass tray.
8) Attach the docking mounting angles.
<1>Cut out the two cut-out portions on the left cabinet of the copier
using nippers or the like.
(Be careful about the orientation of the nippers so that the cross
(Be careful about the orientation of the nippers so that the cross
section is flat.)
<2>Secure the docking mounting angle F and docking mounting
angle R with two screws A (M4 x 10) each.
(F/R is indicated with marking.)
9) Remove the covers from the docking unit.
<1>Remove the screw and slide the top cover in the direction of the
arrow to remove it.
<2>Remove the two screws and then remove the front cover.
<3>Remove the four screws and then remove the left cover.
[03]UNPACKINGANDINSTALLATION.fm 2 ページ ２００４年４月２７日 火曜日 午後７時４分
Click on the first or last page to see other AR-F14 (serv.man3) service manuals if exist.