Read Sharp AR-D28 (serv.man2) Service Manual online
AR-D28/D27/MU2
UNPACKING AND INSTALLATION
4 – 6
<3>Connect the connector (white, 4pin) of power supply I/F harness to
the I/F connector (white, 4pin) of the main unit.
Connect the power supply I/F harness connector (red, 22pin) to
CN11 (red connector) of the PCU PWB of the main unit of the printer.
Remove the M4 screw shown in the illustration, insert the circle ter-
minal of ground harness, and it fixes again.
Connect the power supply I/F harness connector (red, 22pin) to
CN11 (red connector) of the PCU PWB of the main unit of the printer.
Remove the M4 screw shown in the illustration, insert the circle ter-
minal of ground harness, and it fixes again.
*
For installation of a finisher or a mail-bin stacker,
see its installation manual.
6) Attach the harness cover.
Reattach the harness cover to its original position and fix it with the
removed screw.
At this time, ensure that the power supply I/F harness is arranged
as shown in the illustration.
removed screw.
At this time, ensure that the power supply I/F harness is arranged
as shown in the illustration.
• Fix the harness securely to the wire saddle.
*
If another peripheral device must be installed, carry out
the following step at the end of the installation work.
7) Adjust the position of the paper guides of the paper tray.
Refer to "Setting and adjustment" described later.
8) Carry out the off center adjustment.
Connector
CN11
Wire saddle
Harness cover
Screw
Wire saddle
Click on the first or last page to see other AR-D28 (serv.man2) service manuals if exist.