AR-D28 (serv.man2). ARD28 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 8

AR-D28/D27/MU2

UNPACKING AND INSTALLATION

4 – 4

Connect the connector (white, 4pin) of power supply I/F harness to
the I/F connector  (white, 4pin)  of the main unit.

Remove the M4 screw shown in the illustration, insert the circle ter-

minal of ground harness, and it fixes again.

<3>Reattach the harness cover to its original position and fix it with the 

removed screw.

At this time, ensure that the power supply I/F harness is arranged 

as shown in the illustration.

•  Fix the harness securely to the wire saddle.

6) Adjust the position of the paper guides of the upper paper tray of

the stand/paper drawer.
Refer to "Setting and adjustment" described later.

7) Carry out the off center adjustment.

1) Turn off the main switch of the main unit of the printer.

Turn the main switch located on the front side of the main unit to the
"OFF" position.
Then, remove the power plug of the main unit from the outlet.

2) Put the main unit of the printer on the multi purpose drawer.

<1>Pull out the paper tray of the main unit until it stops and then

remove it by lifting both ends of the tray.

<2>Hold the main unit of the printer at the positions shown in the illus-

tration and put the main unit on the multi purpose drawer so that the
front side and the left side of the main unit are aligned to those of
the multi purpose drawer.

Caution: For installation of the main unit, it must be held by two

persons and installed without haste.

Wire saddle

Harness cover

 Power supply
I/F harness

Screw

Wire saddle

Front mounting plates:

 2 pcs.

Rear mounting plates:

 2 pcs.

Screws (M4x8): 

4 pcs.

"OFF"