AR-D28 (serv.man2). ARD28 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 7

AR-D28/D27/MU2

UNPACKING AND INSTALLATION

4 – 3

2) Attach the adjusters and adjust them.

<1>Insert the left adjusters to the stand/paper drawer.

<2>Turn the five adjusters to lower them until they touch the floor.

*

Be sure to attach the left adjuster to prevent overturning.

Caution: The lower tray cannot be pulled out unless the adjuster is low-

ered to the specified position.

3) Put the main unit of the printer on the stand/paper drawer.

<1>Pull out the paper tray of the main unit until it stops and then

remove it by lifting both ends of the tray.

<2>Hold the main unit of the printer at the positions shown in the illus-

tration and put the main unit on the stand/paper drawer so that the
front side and the left side of the main unit are aligned to those of
the stand/paper drawer.

Caution: For installation of the main unit, it must be held by two persons

and installed without haste.

4) Connect the main unit to the stand/paper drawer.

<1>Attach the rear mounting plates using a supplied screw for each.

Caution: Insert the rear mounting plates under the desk frame.

<2>Pull out the upper paper tray of the stand/paper drawer until it stops

and attach the front mounting plates using a supplied screw for each.
Then, remove the lock of the paper tray and close the tray.
Remove the locks of the middle tray and the lower tray similarly.

<3>Reattach the paper tray of the main unit.

5) Connect the power supply I/F harness to the PCU PWB of the

main unit of the printer.

<1>Remove the screw that fixes the harness cover of the main unit of

the printer and slide the harness cover up to remove it.
Process the harness cover as shown in the illustration.

<2>Connect the power supply I/F harness connector (red, 22pin) to 

CN11 (red connector) of the PCU PWB of the main unit of the printer.

1

2

2

2

2

Rear mounting plate

Rear mounting plate

Screw

Screw

Desk frame

Mounting plate

Screw

Screw

Front
mounting plate

Front mounting
plate

Harness cover

Cut out.

Screw

Connector

CN11