Read Sharp AR-CS1 Service Manual online
•
Side connection
Attach the connecting plates to the copier and the desk with the
round hole upside. Insert the connecting screws into the round
holes and fix.
round hole upside. Insert the connecting screws into the round
holes and fix.
Insert the connecting plate cover into the external fitting of the
copier and fix the copier and the desk with the connecting screw.
(1 pc. for each)
copier and fix the copier and the desk with the connecting screw.
(1 pc. for each)
★
The connecting screw serves not only as the fixing screw but also
as an electrical grounding for the copier and the desk. Be sure to
fix the connecting screw.
Install the tray which was removed in procedure 2.
as an electrical grounding for the copier and the desk. Be sure to
fix the connecting screw.
Install the tray which was removed in procedure 2.
4. Remove the package fixture of the tray.
Hold the knob of the tray and pull out the tray from the desk until it
stops.
stops.
Turn the package fixture which is fixing the paper falling/rising plate in
the tray in the arrow direction.
the tray in the arrow direction.
When shipping it is set to A3 size.
When selecting the paper size, perform paper selection.
The procedures are the same as those of the copier.
5. Connect the desk connector.
Remove the connector cover fixing screw for connecting the desk
interface harness connector on the copier side, and remove the con-
nector cover.
interface harness connector on the copier side, and remove the con-
nector cover.
Connect the desk interface harness connector with the copier con-
nector, and tighten the screw of the connector to fix the connector.
nector, and tighten the screw of the connector to fix the connector.
6. Move the copier to the installing position.
7. Lock the caster.
Set the lock lever of the caster which is on the front lower side of the
desk in the arrow direction and lock the caster.
desk in the arrow direction and lock the caster.
8. Fix the desk to the floor.
Loosen the lock nut of the adjuster with a wrench or nippers.
Turn the adjuster in the arrow direction until it reaches the floor. Fix all
the adjusters (4 pcs.) to the floor.
the adjusters (4 pcs.) to the floor.
After fixing the adjusters, turn the lock nut fully upward.
Insert the power plug of the copier into the power outlet, and turn on
the power and perform the following procedures.
the power and perform the following procedures.
Right side
Connecting plate
Connecting screw
Connecting plate cover
Connecting screw
Left side
Connecting plate
Connecting plate
Connecting plate cover
Connecting screw
Left side
Fixture
Connector cover
Fixing screw
Desk side connector
Screw
Lock lever
Lock lever
Lock nut
Adjuster
Lock nut
Adjuster
3 – 4
Click on the first or last page to see other AR-CS1 service manuals if exist.