AR-C260 (serv.man12). (9) Test Simulation - Sharp Copying Equipment Service Manual (repair manual). Page 18

AR-C260/C260M  SIMULATION  9 - 18

(Set content)

∗

The interval time set range is 1 - 999sec. [Default: 3]

∗

The setup contents of this simulation remain unchanged until the 
power is turned off. When SIM 7-1 is executed, the setup contents 
are canceled.

Copying is performed with the color selected in procedure 1).
When no print color is selected, the operation is made with the all 
colors.

The [EXECUTE] key is highlighted. When the adjustment value 
entered in procedure 2) and the corresponding voltage is outputted. 

The voltage is outputted for 30sec, then the [EXECUTE] key returns to 
the normal display. When the EXECUTE key is pressed during output 
of the voltage, the output is stopped and the [EXECUTE] key returns to 
the normal display.

[AGING]

Jam detection setup

[INTERVAL]

Intermittent setup

[MISFEED DISABLE]

Jam detection YES/NO setup

[FUSING DISABLE]

Fusing operation YES/NO detection 

[WARMUP DISABLE]

Warm-up saving setup

[DV CHECK DISABLE]

Developing tank detection YES/NO setup

[SHADING DISABLE]

Shading saving setup

7

-6

Setting/Operation test/check

Used to set the cycle of intermittent aging.

Operation

1. Enter the interval aging cycle time (sec) with the 10-

key pad.

2. Press [OK] key (or B/W Start key, Color Start key) to 

set the entered cycle time.

7

-8

Setting/Operation test/check

Used to set Yes/No of warm-up time display.

Operation

Press the [EXECUTE] key to set the warm-up time 
display.
When the [EXECUTE] key is pressed, the warm-up time 
display setting is executed and the display returns to the 
simulation main code entry display.

7

-9

Setting/Operation test/check

Used to check the image quality and operations of each 
color.

Others

Picture quality

1. Select the color of image quantity and operation 

check with the key.

2. Press the START key.

8

-1

Adjustment/Operation test/check

Used to check and adjust the operations of the 
developing bias voltage of each color and the control 
circuit.

Process 
(Photoconductor, developing, transfer, cleaning)

(

The developing bias output voltage in each of the 

following print modes can be adjusted and checked.)
(Adjustment range)
180 - 700 (Default: See below)
1. Select the color mode with the [K], [C], [M], or [Y] key.
2. Select the copy mode with the scroll key.
3. Enter the adjustment value with the 10-key pad.
4. Press the [EXECUTE] key.