Read Sharp AR-405 Handy Guide online
TECHNICAL UPDATE
SHARP ELECTRONICS (UK) LTD
DOCUMENT SYSTEMS GROUP
45
VERSION 1C
MARCH 2002
MISCELLANEOUS
Model
Fault
Advice
All
Display corrupts when entering Test
Simulation – Continuos Beep also
sounds.
Simulation – Continuos Beep also
sounds.
Faulty/Corrupt OPE Flashcard.
All
Hanging Logo
Check the following :-
1. IC22 (replace if necessary)
2. ICU & OPE flashcards.
3. All DC outputs from PSU
2. ICU & OPE flashcards.
3. All DC outputs from PSU
If Cougar 2k, disconnect all
peripherals and test (eg RADF). If the
machine records a U5 error code, the
copier will not complete its self test
successfully
If IC22 is replaced, use Sim 80-09 to
reset all default settings..
All
Dropping developer.
Check front and rear frame DV seals
for wear or damage. Use modified DV
seals :-
for wear or damage. Use modified DV
seals :-
PSEL-0754FCZ2 & PSEL-0755FCZ2.
All
Machine stops in the middle of a
copy/print job with the message
“Adjust paper guides on the cassette”
(same paper size being used
throughout the job).
copy/print job with the message
“Adjust paper guides on the cassette”
(same paper size being used
throughout the job).
Defective IC22 – replace.
Also check all destination and
language settings in Sim 26..
Also check all destination and
language settings in Sim 26..
All
Slow running.
Check all paper feed tyres – replace if
worn. (The paper feed will retry up to
5 times before indicating a misfeed).
On AR280/285/335 models, check
Sim 26-15 Fuser Curl Prevention
(change from 2 to 0)
worn. (The paper feed will retry up to
5 times before indicating a misfeed).
On AR280/285/335 models, check
Sim 26-15 Fuser Curl Prevention
(change from 2 to 0)
All
Poor fusing after the machine has sat
at idle for approx 5-10 minutes.
at idle for approx 5-10 minutes.
Check & clean all fuser thermistors –
replace if necessary. Also check the
fuser temperature setting using Sim
43.
replace if necessary. Also check the
fuser temperature setting using Sim
43.
All
Not recognising the manual bypass
tray.
tray.
Check for loose connection on the MF
bypass harness. Perform Sim 40-02
to adjust width settings. Also check for
a loose magnet (PG 36-10).
bypass harness. Perform Sim 40-02
to adjust width settings. Also check for
a loose magnet (PG 36-10).
All
Erratic scanner operation/lock ups.
Check for MC/TC arching. Check both
TC lift angles for damge etc.
TC lift angles for damge etc.
All
“Read End” message is displayed
when copying a single page.
when copying a single page.
Sort mode is selected. Change output
default setting to group mode.
default setting to group mode.
Not
AR505/507
Unable to staple in “Covers” mode
with AR-FN2 installed.
with AR-FN2 installed.
Bypass tray disabled when using Off-
Set tray. Reset in “Custom Settings”.
Set tray. Reset in “Custom Settings”.
Click on the first or last page to see other AR-405 service manuals if exist.