Read Sharp AR-337 Handy Guide online
AR-NC3D FLASH UPGRADE
SHARP ELECTRONICS (UK) LTD
DOCUMENT SYSTEMS GROUP
21
VERSION 1C
MARCH 2002
In order to upgrade the AR-NC3D Network Card, Version 1.26d of the FTP flash download
software produced by the network card manufacturers (DPI) should be used.
NOTE
Before upgrading the firmware, obtain a current network card configuration page
software produced by the network card manufacturers (DPI) should be used.
NOTE
Before upgrading the firmware, obtain a current network card configuration page
PROCEDURE
1.
Obtain the latest Flash Memory upgrade file and FTP download software program
from either the Sharp Technical Web Site or “Sharp Eye” CD Disc 1. Place them
into a convenient directory on your PC.
from either the Sharp Technical Web Site or “Sharp Eye” CD Disc 1. Place them
into a convenient directory on your PC.
2.
Both the FTP download program and flash upgrade file will most likely be in a
compressed format. These files will require uncompressing using Winzip or Pkunzip
before the upgrade can be performed.
compressed format. These files will require uncompressing using Winzip or Pkunzip
before the upgrade can be performed.
3.
The uncompressed flash file will be similar to the following:-
Sha572ps.upd
The “sha” denotes the manufacturer type, in our case Sharp. The “572ps” figure denotes
the version number of the Flash Upgrade. The uncompressed flash file is approximately
1MB in size.
the version number of the Flash Upgrade. The uncompressed flash file is approximately
1MB in size.
4.
To install the FTP Download program run the “Set up.exe” program and then
follow the installation wizard.
follow the installation wizard.
5.
Once installed, the FTP Download program can then run.
Ensure that you have version 1.01 by choosing “Help” from the menu system and then
“About FTP”. The version of the software will be displayed.
“About FTP”. The version of the software will be displayed.
6.
The download can now be performed. Select “File” and then “Download” from the
menu. You will then be asked for the upgrade flash file. Select the file and click OK.
menu. You will then be asked for the upgrade flash file. Select the file and click OK.
7.
You are now asked for the IP Address that is set in the AR-NC3D network card of
the copier. Enter the IP Address and click on OK. The download process will now
begin. The download takes approximately 4 minutes. Once completed, all settings
within the AR-NC3d network card will reset to factory default and will need to be re-
configure.
the copier. Enter the IP Address and click on OK. The download process will now
begin. The download takes approximately 4 minutes. Once completed, all settings
within the AR-NC3d network card will reset to factory default and will need to be re-
configure.
Click on the first or last page to see other AR-337 service manuals if exist.