AL-2040 (serv.man2). Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 66

AL-2040  SIMULATION, TROUBLE CODES  10 - 6

26

03

Second cassette setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number of the second cassette is displayed.
2. Enter the code number and press the start key. The setting is changed.

04

Machine duplex setup
(Operation/Procedure)
1. When this simulation is executed, the currently set duplex code number is displayed.
2. Enter the code number corresponding to the duplex and press the ENTER key, and the setup will be changed.

06

Destination setup
When this simulation is executed, the current setup of the destination code number is displayed. Enter the code number 
corresponding to the destination and press the PRINT switch to enable the setup.

07

Machine conditions check
When this simulation is executed, the current machine setup is displayed.

20

Rear edge void setup
When this simulation is executed, the current setup of the rear edge void code number is displayed. Enter the code number 
corresponding to the rear edge void and press the PRINT switch to enable the setup.

30

CE mark support control ON/OFF
When this simulation is executed, the current setup of the CE mark support code number is displayed. Enter the code number 
corresponding to the CE mark support setup and press the PRINT switch to enable the setup.

38

Cancel of stop at drum life over
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the 
PRINT switch to enable the setup.

39

Memory capacity check
When this simulation is executed, the current memory capacity is displayed.

40

Polygon motor OFF time setup (Time required for turning OFF after completion of printing)
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the 
PRINT switch to enable the setup.

Main 
code

Sub 

code

Content

Code number

Second cassette

0

Without second cassette

1

With second cassette

Code number

Duplex

0

Without Duplex

1

With Duplex

Code number

Destination

0

Inch series

1

AB  series

CPM

Copy quantity display

20 cpm 

20

Code number

Rear edge void setup

0

Rear edge void not provided

1

Rear edge void provided * Default

The default for CE-support 200V series is “1.”

Code number

CE mark support setup

0

CE mark support control OFF * Default (100V series)

1

CE mark support control ON

Code number

Setup

0

Stop at drum life over * Default (AL model)

1

Cancel of stop at drum life over

Code number

Setup

8

8 Mbyte

16

16 Mbyte

Code number

Setup

0

0 sec

1

30 sec * Default

2

60 sec

3

90 sec