AL-1566 (serv.man8). Unpacking and installation - Sharp Copying Equipment Service Manual (repair manual). Page 2

AL-1556/1566  UNPACKING AND INSTALLATION  5 - 2

Be sure to hold the handles on both sides of the machine to unpack the
machine and carry it to the installation location.

1) Remove all pieces of tape shown in the illustration below and then

open the RSPF and remove the protective materials. Take out the
bag containing the TD cartridge.

2) Release the scan head locking switch.

1) Open the bypass tray, and then open the side cover.

2) Remove the CAUTION tape from the front cover and remove the

two protective pins from the fusing machine by pulling the strings
upward one at a time.

3) Press gently on both sides of the front cover to open the cover.

4) Remove the TD cartridge from the bag. Remove the protective

paper. Hold the cartridge on both sides and shake it horizontally
four or five times. Hold the tab of the protective cover and pull the
tab to your side to remove the cover.

5) While pushing the lock release button, gently insert the TD car-

tridge until it locks into place.

6) Close the front cover and then the side cover by pressing the round

projections near the side cover open button.

Note: When closing the covers, be sure to close the front cover

securely and then close the side cover. If the covers are closed
in the wrong order, the covers may be damaged.

7) Ensure that the power switch of the machine is in the OFF position.

Plug the other end of the power cord into the nearest outlet.

Grasp here and turn in 
the direction of the arrow.

CAUTION tape

Protective pins

4 or 5 times

Lock release button