Read Sharp PN-E802 (serv.man3) Service Manual online
CHAPTER 6. DISASSEMBLY AND ASSEMBLY
PN-E802/E702/E602 DISASSEMBLY AND ASSEMBLY
6 – 23
12. SPEAKER L/R
1 ) Remove four screws
A (M3 x 6, Silver), remove four screws B (M3 x 10, Silver), and remove the speaker cover.
CAUTION
NOTE FOR ASSEMBLY AND DISASSEMBLY
n
Peel off the cushion partly when remove the screw
B. (PN-E802 only)
n
Be careful not to pinch the speaker cable.
SCREW TIGHTENING TORQUE
n
Screw
A: 0.7 - 0.9N•m
n
Screw
B: 0.55 - 0.65N•m
2 ) Remove two Faston terminals and two screws (M3 x 6 SW+W, Silver), remove two plain washers, and remove the speakers L/R.
CAUTION
NOTE FOR ASSEMBLY
n
The speakers L/R have an engraved mark for identification. Do not install it in the opposite direction.
n
Insert the Faston terminals securely to the bottom to fix firmly.
SCREW TIGHTENING TORQUE
n
0.7 - 0.9N•m
Band
A
Screw
x 4
B
Screw
x 4
Speaker
cover
cover
Speaker cable
When assembling, put the binding band of the
speaker cable inside the cover.
Slightly pull the speaker cable until it is
stopped by the binding band inside the cover.
speaker cable inside the cover.
Slightly pull the speaker cable until it is
stopped by the binding band inside the cover.
Cution A
L-ch
R-ch
Speaker L
Speaker R
Screw x 2
Washer x 2
Washer x 2
Screw x 2
Washer x 2
Washer x 2
Mark
Mark
Faston terminal
Red
Black
Pull it out while
holding down the
part below.
holding down the
part below.
Click on the first or last page to see other PN-E802 (serv.man3) service manuals if exist.