PN-655RE (serv.man3) - Sharp Monitor Service Manual (repair manual). Page 2

PN-655RU/655RE   

■ Mounting precautions

This monitor should be used at an ambient temperature between 32 °F
(0 °C) and 104 °F (40 °C). Provide enough space around the monitor

to prevent heat from accumulating inside.

If it is difficult to provide such space because the monitor is installed

inside a housing or for other reasons, take other measures to keep the

ambient temperature between 32 °F (0 °C) and 104 °F (40 °C) such as
installing a fan in the housing.

■

The carrying handles are detachable. When carrying the monitor,

attach the four supplied carrying handles to the monitor as shown
below. To attach the carrying handles, remove the existing screws from

the monitor, and attach the handles with the supplied screws.

After you removed the handles, be sure to replace the removed screws

in the original holes.

■

Note that the values shown are approximate values.

When mounting the monitor, read the manual of the brackets or stand for their mounting procedure. The screw holes for mounting brackets (M10 

u

4 holes) are provided on the rear of the monitor. Note that screw hole depth of the monitor is 1-3/16 inch (30mm). Loose holding may cause the prod-

uct to fall, resulting in serious personal injuries as well as damage to the product. The screw and hole should come together with over 3/4 inch (20mm)
length of thread. SHARP recommends using mounting interface that comply with UL1678 standard.

11-13/16 [30]

1-3/4 [4.5]

1-15/16 [5]

1-15/16[5]

1-15/16 [5]

Unit: inch [cm]

The Power LED must be on the lower side.

59-

7

/ 16

 [1509]

Opening height (56-

3

/ 8

 [1432])

61-

7

/ 8

 [1572]

25-

9

/ 16

 [650]

34-5/16 [871]

Unit: inch [mm]

1/4 [6] 5-7/8 [150]

36-5/16 [923]

Opening width

31-3/4 [807]

39-1/2 [1003]

17-5/16 [440]

1-9/16
    [40]

1-9/16
[40]

Screw holes for mounting brackets