LL-T2000A (serv.man9). Complete - Sharp Monitor Service Manual (repair manual). Page 7

LL-T2000A

2 – 3

Notes: • Depending on the computer or OS, it may be necessary to

use the computer to install monitor set-up information. If so,
follow the steps below to install the monitor set-up informa-
tion.

•  When setting up the monitor or a connected computer for the

first time, connecting an additional computer or after having
changed an aspect of the current system, perform an auto-
matic screen adjustment before use.

0

0

0

0

When connected to two computers, use the INPUT button to switch
between input signal terminals (i.e. to choose which computer's
screen you want displayed.)

1.  Turn the computer off.

2.  Press the monitor's power button.

The Power LED will disappear.
If the monitor is not going to be used for a long period of time, be
sure to unplug it from the AC outlet.

An arm or stand based on the VESA standard (purchased separately)
can be attached to the monitor.

Procurement of the arm or stand is at the customer's discretion.

*

Attachments must satisfy the following.

*

Compatible with the VESA standard

*

Have a gap of at least 100 mm 

u

 100 mm between the screw holes

on the section to be attached

*

Not be likely to fall off or break off after being attached to the moni-
tor.

Notes: • Do not bend the signal cable or the AC adapter cable nor

place weight on them. Doing so could lead to damage.

• While following these instructions, please also refer to the

installation instructions in the operation manual included with
the arm or stand.

1.  Spread out a soft cloth on a suitable horizontal surface.

2.  Being careful not to damage the monitor, gently lay the monitor on

it display-side down.

3.  Remove the stand cover and the covers to the left and to the right.

4.  Remove the two screws, and remove the cover.

5.

Remove the four screws and then remove the stand from the monitor.

6.

Attach the arm to the monitor with the four screws.

INPUT button
Pushing this button switches between input 
signal terminals, so that the screen changes to 
display any of the machines connected.

OFF

Turn off device to 
which monitor is 
connected

Turn monitor off 

Press power button

(Rear view)

Stand cover

Lift one side

Cover

Two screws

Stand

8~10mm

The screws used to attach the arm should be M4 screws 
with a length of 8 mm ~ 10 mm protruding from the surface 
to be attached. 
Using any other kind of screw may lead to the monitor 
falling off or damage to the internal part of the monitor

Screw used to attach arm

Arm

Part of monitor to which arm is attached