Read Sharp LL-T181A (serv.man3) Service Manual online
Adjusting the Angle of the Monitor
When adjusting the angle of the LCD screen, hold the foot of the
stand to prevent it from falling.
stand to prevent it from falling.
Notes:
·
Please set the FRONT
mark on the bottom turn plate
to the front of the monitor. The monitor swivels symmetri-
cally.
cally.
·
Do not touch the screen surface when you swivel and tilt
the monitor.
the monitor.
1-1. When the AC adapter is to be installed outside
Remove the stand rear cover.
Remove the power supply terminal cover.
Connect the AC adapter to the monitor.
Install the power supply terminal cover.
Install the stand rear cover.
Connect the AC power supply cord to the AC adapter and the AC
plug to the wall outlet.
plug to the wall outlet.
Connect the signal cable to the analog terminal of the computer.
Make sure to secure the signal cable by tightening the screws.
Make sure to secure the signal cable by tightening the screws.
When you are using a Power Macintosh, read "3. In the case of
connecting to Power Macintosh."
connecting to Power Macintosh."
Turn on the power-on switch of the monitor and then turn on the
power-on switch of the computer. The power-on lamp comes on in
green and the screen appears.
power-on switch of the computer. The power-on lamp comes on in
green and the screen appears.
Then, adjust the screen. to Automatic screen adjustment
Slide the cover upward
by holding it with your
hands as shown in the
drawing.
by holding it with your
hands as shown in the
drawing.
Sliding the cover
upward disengages it.
Then, remove the
cover, pulling it up from
the bottom.
upward disengages it.
Then, remove the
cover, pulling it up from
the bottom.
Tilt the top of the display
all the way back as
shown.
all the way back as
shown.
Slide the power jack
cover downward to
remove it.
cover downward to
remove it.
Feed the AC adapter cord
through the hole in the upper
section of stand from the rear
side, and connect it with the AC
adapter jack.
through the hole in the upper
section of stand from the rear
side, and connect it with the AC
adapter jack.
Feed the AC adapter cord
through the hole in power
jack cover.
through the hole in power
jack cover.
Fit the cover at the top end first,
then slide the cover downward to
lock it.
then slide the cover downward to
lock it.
DC Plug
DC Cord
AC Power Cord
AC Plug
To the Outlet
AC Adapter
Click on the first or last page to see other LL-T181A (serv.man3) service manuals if exist.