Read Sharp LL-T181A (serv.man3) Service Manual online
Install the stand rear cover.
Connect the AC plug into the wall outlet.
Connect the signal cable to the analog signal terminal of the com-
puter. Secure the signal cable by tightening the screws.
puter. Secure the signal cable by tightening the screws.
When you are using a Power Macintosh, read "3. In the case of
connecting to Power Macintosh."
connecting to Power Macintosh."
Turn on the power-on switch of the monitor, then turn on the
power-on switch of the computer. The power-on lamp comes in
green and the screen appears.
power-on switch of the computer. The power-on lamp comes in
green and the screen appears.
Then, adjust the screen. to Automatic screen adjustment
2. Cautions to be taken when installing a VESA
standard compatible arm . (reference)
Note:
An arm and stand should be prepared by the customer.
When installing such an arm and stand on this monitor
When installing such an arm and stand on this monitor
·
They are VESA standard compatible and have the spacing
between the screws which go to the monitor is 100 mm x 100
mm.
between the screws which go to the monitor is 100 mm x 100
mm.
·
They should be strong enough to install the monitor
Put a soft cloth to prevent damage to the monitor.
Put the monitor on a horizontal place with the display surface
pointed down.
Put the monitor on a horizontal place with the display surface
pointed down.
As shown in the sketch, remove the 2 screws with a screwdriver
and remove the hinge cover. Remove the 6 screws from the stand
and remove the stand.
and remove the hinge cover. Remove the 6 screws from the stand
and remove the stand.
As shown in the sketch, secure the arm with 4 screws.
When installing the arm or stand, read its Instruction manual.
Remove the power supply terminal cover and connect the AC
adapter t the monitor.
adapter t the monitor.
Connect the AC power supply cord to the AC adapter and the AC
plug to the wall outlet.
plug to the wall outlet.
Connect the signal cable to the analog terminal of the computer.
Secure the signal cable with the screws.
When you are using a Power Macintosh, read "3. In the case of
connecting to Power Macintosh."
Secure the signal cable with the screws.
When you are using a Power Macintosh, read "3. In the case of
connecting to Power Macintosh."
Turn on the power-on switch of the monitor and then turn on the
power-on switch of the computer. The power-on lamp comes on in
green and the screen appears.
power-on switch of the computer. The power-on lamp comes on in
green and the screen appears.
Then, adjust the screen. to Automatic screen adjustment
Fit the cover at the top end first,
then slide the cover downward to
lock it.
then slide the cover downward to
lock it.
Hinge Cover
Arm Mounting Position
M4 Screw
Mounting Arm
Monitor
8-10mm
CAUTION
Secure the arm using (4) M4
screws whose length
from the end of the arm
mounting surface is 8 to 10
mm. Otherwise, screws may
not engage fully or may
damage the inside of
Secure the arm using (4) M4
screws whose length
from the end of the arm
mounting surface is 8 to 10
mm. Otherwise, screws may
not engage fully or may
damage the inside of
DC Plug
DC Cord
AC Power Cord
AC Plug
To the Outlet
AC Adapter
Click on the first or last page to see other LL-T181A (serv.man3) service manuals if exist.