Read Sharp UP-3515 (serv.man8) User Guide / Operation Manual online
– 6 –
7) Insert the expansion RAM board into the slot, and press it until it
locks securely.
*
When inserting, be careful not to put the machine down.
8) Remove the rear cabinet and the front cabinet. Connect the
harness of the battery.
9) Attach the front cabinet and the rear cabinet.
10) Turn on the power, and perform MASTER RESET 1 and the
calibration.
Follow the procedures below for MASTER RESET 1 and the calibration
operation.
operation.
1) Set the reset switch to ON position and move the reset switch to
OFF position.
In this time, if the calibration operation for the touch key hasn't done,
execute the calibration operation.
In this time, if the calibration operation for the touch key hasn't done,
execute the calibration operation.
2) The menu window opens.
(Selectable 2 keys, [PROGRAM RESET] and [MASTER RESET].)
Then select [MASTER RESET].
Then select [MASTER RESET].
3) The menu window opens.
(Selectable 3 keys, [MASTER RESET 1], [MASTER RESET 2] and
[MASTER RESET 3].)
[MASTER RESET 3].)
4) Select [MASTER RESET 1] and enter the secret number.
5) Perform the calibration operation.
*
Secret number for MRS-1: 11111111
*
Meaning of reset switch “ON” & ”OFF” positions are as follows.
ON position: The position that CKDC becomes reset state
(Reset status)
OFF position: The position that CKDC becomes active state
(Normal status)
9. ACCESSORY ASSEMBLY
1. Accessory
2. SET UP
1) To attach the FOOT SUPPORTER, turn the bottom of the UP-3515
upside. (Put the UP-3515 on a soft sheet not to scratch the sur-
face.)
face.)
2) POSITION: “A/B/C/D” 4 positions
Pinch the T/GUM LEG already attached, and remove it from the
BOTTOM CABINET.
BOTTOM CABINET.
FOOT SUPPORTER: 4pcs
RUBBER FOOT: 4pcs FOOT SPACER: 4pcs
SCREW (M4 x 26): 4pcs
POSITION "A"
POSITION "D"
BOTTOM
CABINET
BOTTOM
POSITION "C"
POSITION "B"
BOTTOM
CABINET
T/GUM LEG
T/GUM LEG
Click on the first or last page to see other UP-3515 (serv.man8) service manuals if exist.