Read Sharp HT-SB60 (serv.man7) Technical Bulletin online
AUD 2013 04 08
Date of Issue: 29
th
April 2013
Classification:
White
AUDIO TECHNICAL BULLETIN
Page 4 of 6
Sharp Electronics (UK) Limited
Reference
– TSI-1330003
Revision - 2
White
– Carry out as required
Yellow
– Carry out as required and whenever the unit comes in for service
Red
– Carry out on all units
Flash Writer Connection
The connection between Flash Writer and Main Unit is shown as below.
The connection between Flash Writer and Main Unit is shown as below.
Flash Programming
1. Insert the FFC cable into the flash terminal at the bottom cabinet of the Main Unit (HT-SB60).
2. Plug the AC cord into an AC supply. The HT-SB60 LED lights up and the Flash writer
2. Plug the AC cord into an AC supply. The HT-SB60 LED lights up and the Flash writer
POWER, PASS & ID ERR indicators will light up.
3. Press the START button on the jig to start programming.
4. The PASS indicator will flashing during programming
5. The PASS indicator will permanently light up once programming is completed.
6. Remove the AC cord from the AC supply.
7. Remove the FFC cable from the Main Unit.
4. The PASS indicator will flashing during programming
5. The PASS indicator will permanently light up once programming is completed.
6. Remove the AC cord from the AC supply.
7. Remove the FFC cable from the Main Unit.
Confirmation of Updated Software Version
1. Plug the AC cord into the AC supply while holding down the "STANDBY" and "INPUT"
buttons on the main unit.
2. The Display appears as -
SB60 1026
3. Press the STANDBY button again to return back to normal operation.
Click on the first or last page to see other HT-SB60 (serv.man7) service manuals if exist.