Read Panasonic PT-RZ670 / PT-RW630 (serv.man13) Other Service Manuals online
SECTION 2 DISASSEMBLY PROCEDURES
< RZ670/RW630 >
3. Unscrew the 3 screws and remove the Trim wheel cover.
[Coution] ・Carefully pull out the flexible cable of trim wheel from the through slit of the dust protection sheet.
・When re-assembling, make sure flexible cable is properly placed without slackness.
1) Unscrew the 2 screws and remove the Trim plate.
2) Unscrew the 3 screws and remove the Trim wheel.
（Torque:22±2 N・cm）
4. Unscrew the 6 screws and remove the DMD block.
[Coution] ・Refer section 2.1 to remove the flexible cables.
5. Unscrew the 4 screws and remove the heatsink.
[ Note for re-assembling ]
・ Apply the heat dissipation compound evenly to the rear surface of DMD heatsink.
・ Take care that compound does not stick out.
・ Take care that compound does not stick out.
Trim wheel cover
DMD block
Apply heat dissipation compound
Heatsink
Heat-sink
Smaller R of
spring to screw head
spring to screw head
3
6
4
3
2
Heat dissipation compound :
Shin-Etsu Silicone [ G-776 ] grade
Shin-Etsu Silicone [ G-776 ] grade
DIS-12
Click on the first or last page to see other PT-RZ670 / PT-RW630 (serv.man13) service manuals if exist.