FZ-A1BDAAXXM, FZ-A1BDAAEE9, FZ-A1BDAAZE9 - Panasonic PC Service Manual (repair manual). Page 38

1. Connect the DC PCB Cable of connector. (DCCN1)
2. Attach the DC PCB and DC IN Bracket, and tighten 1 Screw<N1>.

Screw<N1> : DRHM0212ZA

■ Attachment of DC PCB

DC PCB

Screw<N1>

DC IN Bracket

Connector
(DCCN1)

Figure 1

Figure 2

Figure 3

Figure 4

*Notice
<Screw tightening torque>
Screw<N1> = 0.165 ± 0.01N·m (1.65 ± 0.1kgf·cm)
<Screw tightening order>
Screw<N1> = 1 - 2 - 3

Set the cable 
along the edge 
of Main PCB.

1. Put the Support Bracket at the position as shown 
    in the figure, and then tighten screws*2.
2. Insert the DC IN Cabel into the Main PCB 
    connecter interface parallelly with pin downwards.
    

Note: Ensure that the cable is inserted to the bottom.

3. Position the DC PCB on the Lower Case / Speaker Ass'y.
4. Position the DC IN Bracket on the Lower Case / Speaker Ass'y, and then tighten screws*1.
    

Note: After the positioning is OK, settle the DC IN cable along the Main PCB edge.

Support Bracket

DC PCB

DC IN Bracket

Screw<N1>

Screw<N1>

Screw<N1>

1

2

3

7-10