Read Panasonic FZ-A1BDAAXXM / FZ-A1BDAAEE9 / FZ-A1BDAAZE9 Service Manual online
■ Preparation of each component
1. Take Main PCB, unpack it, and check the version of Main PCB and part numbers.
There is no damage, defect, All connecters and interfaces must not be damaged, defected,
high warp/subsidence/skew/distortion, shaking, and dirty on all connecters and interfaces.
Check whether there is any subsidence, distortion, and deficiency on the EMI spring*5.
There is no damage, defect, All connecters and interfaces must not be damaged, defected,
high warp/subsidence/skew/distortion, shaking, and dirty on all connecters and interfaces.
Check whether there is any subsidence, distortion, and deficiency on the EMI spring*5.
Note:
2. Remove the Solder Mask Tape from the area covering the camera lens under cabinet.
3. Paste 1pcs Conductive Tape at the position 3.4 mm from the upper edge of the aluminum
sheet as the shown in the figure (using gauges).
4. Remove the 5M Camera & WWAN (
3. Paste 1pcs Conductive Tape at the position 3.4 mm from the upper edge of the aluminum
sheet as the shown in the figure (using gauges).
4. Remove the 5M Camera & WWAN (
WWAN model
) and upper foam.
Check whether there is any subsidence or distortion
on the spring*5. If yes, adjust it with gauges.
on the spring*5. If yes, adjust it with gauges.
MB55 barcode
5M Camera
WWAN barcode
Paste the 1pcs Conductive
Tape as shown in the figure.
Tape as shown in the figure.
If the Main PCB spring is distorted, use the gauge to hold up the spring edge.
If the preceding operation is ineffective, the Main PCB is NG.
If the preceding operation is ineffective, the Main PCB is NG.
7-6
Click on the first or last page to see other FZ-A1BDAAXXM / FZ-A1BDAAEE9 / FZ-A1BDAAZE9 service manuals if exist.