Read Panasonic WV-NW470S / WV-NW474SE Service Manual online
1-1
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
A
B
L
EFT
R
IGHT
U
P
D
OWN
SET
LINK
LED
OFF
LED
ON
RCV
A
B
L
EFT
R
IGHT
U
P
D
OWN
SET
LINK
LED
OFF
LED
ON
RCV
u
i
i
o
!0
!1
!1
!2
!3
!4
!5
!6
!7
!4
!5
!6
!7
!9
!8
t
r
q
y
w
Transport Protection
Screws (Red)
Screws (Red)
e
q
Tilting lock screw
Fixes the tilting position.
w
Panning table
Adjusts the panning angle of the camera.
e
Azimuth adjuster
Adjusts the azimuth angle to level the image.
r
Pan lock screw
Fixes the panning position.
t
Zoom lock lever
Fixes the zoom position after adjustment.
y
Focus lock lever
Fixes the focus position after adjustment.
u
Optional heater connector
When an optional heater unit is installed in the camera, the
harness exiting from the unit will be connected to this.
harness exiting from the unit will be connected to this.
i
Reset button (A)
Holding down the Up and Down buttons simultaneous for
15 seconds in the power-on state will reset the network
setup parameters.
15 seconds in the power-on state will reset the network
setup parameters.
Note:
Never press both reset buttons A and B at the same
time.
o
Reset button (B)
Holding down the Up and Down buttons simultaneously for
15 seconds in the power-on state will reset the HTML files
and alarm mail setup.
15 seconds in the power-on state will reset the HTML files
and alarm mail setup.
!0
LED switch
ON:
ON:
Enables the LINK and RCV LEDs to indicate
the communication status.
OFF:
Disables the status indication.
Note:
Normally set the switch to OFF. Set it to ON
only when you check the communication status. Failure
to do so may cause disturbance to the camera image, or
light leakage to the outside of the camera in dark places.
to do so may cause disturbance to the camera image, or
light leakage to the outside of the camera in dark places.
!1
Link indicator (LINK)
Lights up when establishing communications via the net-
work if the LED switch is set to ON.
work if the LED switch is set to ON.
!2
Receive indicator (RCV)
Lights up when receiving data via the network if the LED
switch is set to ON.
switch is set to ON.
!3
Left button (Left)
Moves the cursor to the left, selects the mode, and adjusts
some levels.
some levels.
!4
Right button (Right)
Moves the cursor to the right, selects the mode, and adjusts
some levels.
some levels.
!5
Up button (Up)
Moves the cursor upward and selects items in the menu
setup.
setup.
!6
Down button (Down)
Moves the cursor downward and selects items in the menu
setup.
setup.
OFF
ON
Click on the first or last page to see other WV-NW470S / WV-NW474SE service manuals if exist.