WV-NW470S, WV-NW474SE - Panasonic Video Monitoring Service Manual (repair manual). Page 2

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, 
DO NOT REMOVE COVER (OR BACK). NO USER 
SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.

This symbol warns the user that uninsulated voltage within 
the unit may have sufficient magnitude to cause electric 
shock. Therefore, it is dangerous to make any kind of contact 
with any inside part of this unit.

This symbol alerts the user that important literature concerning 
the operation and maintenance of this has been included.
Therefore,  it  should  be  read  carefully  in  order  to avoid 
any problems.

T

here are special components used in this equipment which are important for safety. These parts are indicated 

by the ”

 

Y

 

” mark on the schematic diagram and the replacement parts list. It is essential that these critical 

parts should be replaced with manufacturer's specified parts to prevent X-radiation, shock, fire, or other hazards.

Do not modify the original design without permission of manufacture.

PCBs (manufactured) using lead free solder (PbF) will have a stamp on the PCB.

8

Lead free solder has a higher melting point than standard solder. Typically the melting points is 35 

°

C – 40 

°

C

(95 

°

F – 104 

°

F) higher. Please use a soldering iron with temperature control and adjust it to 360 

°

C – 370 

°

C

(680 

°

F – 698 

°

F). In case of using high temperature soldering iron, please be careful not to heat too long.

8

Lead free solder will tend to splash when heated too high (600 

°

C / 1112 

°

F).

8

Lead free solder (Sn - 3.0Ag – 0.5Cu) or equivalents are recommended on repairing our lead free soldered PCB.

Y

   WARNING

This service information is designed for experienced repair technicians only and is not designed for use by the 
general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to 
service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any 
attempt to service or repair the product or products dealt with in this service information by anyone else could 
result in serious injury or death.

The lithium battery in this equipment must only be
replaced by qualified personnel. When necessary,
contact your local Panasonic supplier.

Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recom-

mended by the equipment manufacturer. Discard used

batteries according to manufacture's instructions.