WV-NM100 - Panasonic Video Monitoring Service Manual (repair manual). Page 8

– 5 –

(1).Connect the Network Camera (WV-NM100) and the PC directly by using the Ethernet Cable (Category 5 Cross Cable).

AC Adapter 

To Outlet 
(120 V AC for NTSC model)
(230 V AC for PAL model) 

Ethernet Cable 
(Category 5 Cross Cable)

Network Camera
WV-NM100

(2).Reset the Network Camera. (All settings data return to the default settings.)

Note: It cannot be backup of the settings data. Before reseting the Network Camera, prease record to the Paper for keep the 

Setting Contents of the Network Setup Page.

Connector Cover

Document Initialization Switch

Setting Reset Switch

• All settings return to the default settings when the AC Adapter is plugged into the Outlet while the Setting Reset Switch on the

Rear side of the Network Camera is pressed and kept pressed for 5 seconds or more after the plug is inserted.
Note: It will take around 2 minutes to reset all settings. Cannot be access to the Network Camera during the reset operation

and after the power is supplied.

(First, the Power LED is blinks around 80 seconds, and next, the panning and tilting of the Camera is operate around  

20 seconds. Can be access to the Network Camera after the above operation has been completed.)

• All HTML documents return to the default settings when the AC Adapter is plugged into the Outlet while the HTML Document

Initialization Switch on the Rear side of the Network Camera is pressed and kept pressed for 5 seconds or more after the plug
is inserted.
Note: It will take around 5 minutes to initialize all HTML documents. The power LED blinks during the initialization. It changes

to steady light after the initialization has been completed.

To set up the Network of the PC, first change the TCP/IP settings of the PC to match them to the default settings of the Network
Camera. The following are the default Network settings of the Network Camera.

• IP Address:

192.168.0.10

• Subnet Mask:

255.255.255.0

• Default Gateway: 192.168.0.1

To access the Network Camera, the IP Address of the PC should be "192.168.0.XXX" (where XXX should be a number from 2 to
254 except 1 and 10). In case the IP Address of the Network Camera is set with the "Panasonic IP Setup" software, perform the
Network setting of the PC according to the Network environment.
The settings differ depending on which OS is installed on the PC. (Refer to page 6)