Read Panasonic WV-CPR460 / WV-CPR464E Service Manual Simplified online
WV-CPR460 Series
– 5 –
4.3. Setting Up
An initial setting of the Switches on the Left side Panel of
the WV-CPR460 and WV-CPR464E are as follows:
Gen-Lock Termination Switch
the WV-CPR460 and WV-CPR464E are as follows:
Gen-Lock Termination Switch
(Hi-Z-G/L 75
Ω
)
. . . . . . . . . . . . . .
G/L 75
Ω
RS-485 Temination Switch
(Hi-Z-DATA TERM)
(Hi-Z-DATA TERM)
. . . . . . . . . . .
DATA TERM
Full-Duplex/Half-Duplex Selection Switches
(4-LINE-2-LINE)
(4-LINE-2-LINE)
. . . . . . . . . . . . . . .
2-LINE
The adjustments should be done with this initial setting,
unless otherwise specified.
unless otherwise specified.
The adjustments should be done after 10 minutes warm
up.
up.
5. Adjustment Procedure
<Adjustment Procedure-1>
1. Flange-back Adjustment
Test Point:
CN2 (Video Output Connector)
I/F Board
Adjust:
Flange-back Adjusting Ring
Mount the ALC Lens WV-LA9C3B on the Camera.
Set the Radiation Chart.
Aim the Camera at the Radiation Chart distance of 10m.
Set the Lens Focus Ring so that the Lens Focus positions
approx. 9mm in front from infinity.
Referring to Fig. 5-1, loosen the Focus-Fixing Screw that
secure the Flange-back Adjusting Ring.
Adjust the Flange-back Adjusting Ring to obtain best
focal point.
Set the Radiation Chart.
Aim the Camera at the Radiation Chart distance of 10m.
Set the Lens Focus Ring so that the Lens Focus positions
approx. 9mm in front from infinity.
Referring to Fig. 5-1, loosen the Focus-Fixing Screw that
secure the Flange-back Adjusting Ring.
Adjust the Flange-back Adjusting Ring to obtain best
focal point.
Fig. 5-1
Focus-Fixing Screw
Flange-back
Adjusting Ring
Tighten the Focus-Fixing Screw that secure the Flange-
back Adjusting Ring carefully.
Change the ALC Lens to WV-LA9C3A from WV-LA9C3B.
back Adjusting Ring carefully.
Change the ALC Lens to WV-LA9C3A from WV-LA9C3B.
<Adjustment Procedure-2>
(E.V.R. Adjustment)
Insert new disk containing the E.V.R. Adjustment pro-
gram into IBM PC/AT.
To change communication mode of the camera, turn off
the power for the camera.
Turn on the power for the camera while pressing both
Left and Right Buttons on the Left side panel of the cam-
era.
At the prompt, type RADJ CPR460E and press the
ENTER key, an initial menu will be displayed in Table 5-1.
gram into IBM PC/AT.
To change communication mode of the camera, turn off
the power for the camera.
Turn on the power for the camera while pressing both
Left and Right Buttons on the Left side panel of the cam-
era.
At the prompt, type RADJ CPR460E and press the
ENTER key, an initial menu will be displayed in Table 5-1.
Press the SAVE(F5) key of the Computer, then the
Computer will ask you for the file name.
Give appropriate file name to the Computer. But do not
use CPR460E.EVR for your file.
This saving procedure is recommended to keep the cur-
rent adjustment status of the Camera.
Press the LOAD(F1) key and type CPR460E.EVR and
press the ENTER key for presetting adjustment of the
Camera.
Computer will ask you for the file name.
Give appropriate file name to the Computer. But do not
use CPR460E.EVR for your file.
This saving procedure is recommended to keep the cur-
rent adjustment status of the Camera.
Press the LOAD(F1) key and type CPR460E.EVR and
press the ENTER key for presetting adjustment of the
Camera.
Notes:
Adjustment items are exactly same as WV-CP460 Series.
Difference point is just file name.
Please kindly refer original manual.
Difference point is just file name.
Please kindly refer original manual.
Table 5-1
PANASONIC REMOTE EVR ADJUSTMENT SYSTEM (C) MCI Co. CCTV PRODUCT:CPR460 EEPROM:0
✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽
MENU
✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽ ✽
Page (1/1)
✽ ✽ ✽ ✽ ✽
PAL
1.1. SC FREQUENCY
1.2. VS SC FREQUNCY
2. HI CLIP LEVEL
3. ALC DC
4. VIDEO OUT GAIN
5. PEDESTAL
6.1. BURST LEVEL
6.2. BURST LEVEL
6.3. BURST LEVEL
6.4. BURST LEVEL
7.1. WB 3200K MANU OFFSET R
7.2. WB 3200K MANU OFFSET B
8.1. WB 6500K ATW LIMIT R
8.2. WB 6500K ATW LIMIT B
9.1. 3200K R_GAIN
9.2. 3200K B_GAIN
9.3. 3200K MATRIX
10.1. 5100K R_GAIN
10.2. 5100K B_GAIN
11. HI LIGHT CHROMA CLIP
<CONTENTS>
1.2. VS SC FREQUNCY
2. HI CLIP LEVEL
3. ALC DC
4. VIDEO OUT GAIN
5. PEDESTAL
6.1. BURST LEVEL
6.2. BURST LEVEL
6.3. BURST LEVEL
6.4. BURST LEVEL
7.1. WB 3200K MANU OFFSET R
7.2. WB 3200K MANU OFFSET B
8.1. WB 6500K ATW LIMIT R
8.2. WB 6500K ATW LIMIT B
9.1. 3200K R_GAIN
9.2. 3200K B_GAIN
9.3. 3200K MATRIX
10.1. 5100K R_GAIN
10.2. 5100K B_GAIN
11. HI LIGHT CHROMA CLIP
<CONTENTS>
17734470 + - 40Hz
<INSTRUCTION> PLEASE CHOOSE MENU DATA BY ARROW-KEY
LOAD (F1) QUIT (F3) SAVE (F5)
Click on the first or last page to see other WV-CPR460 / WV-CPR464E service manuals if exist.