Read Panasonic WV-CPR460 / WV-CPR464E Service Manual Simplified online
4. Connection and Setting Up for
Adjustment
4.1. Connection
The Fig. 4-1 shows the connecting diagram for the adjust-
ment procedure.
ment procedure.
Fig. 4-1
Test Chart
Lens
Lcm
Floppy
Disk
Disk
Under scanned
Colour
Video Monitor
Colour
Video Monitor
Video Signal Generator
Remote E.V.R.
Adjustment
Kit
12V DC
Power Supply
Power Supply
RS-232C
Straight
Cable
Straight
Cable
Conversion
Cable
Cable
Personal
Computer
Computer
75
Ω
CAMERA
Waveform
Monitor
Monitor
Vectorscope
CAMERA
IN
VIDEO
OUT
VIDEO
OUT
GEN-LOCK
12V DC or 24V AC
Power Supply
Power Supply
220-240V AC (for WV-CPR460)
(for WV-CPR464E)
– 4 –
WV-CPR460 Series
4.2. Setting Up for New E.V.R. Adjustment
Kit
< Remote E.V.R. Adjustment Kit >
REMOTE
OPERATE
PROG
ALARM
RESET
RESET
NORMAL
SYSTEM
ALARM OFF
EVR
Left
Switch
Switch
Right
Switch
Switch
Mode Selection
Switch
Switch
Program
Switch
Switch
Up
Switch
Switch
Down
Switch
Switch
Set
Switch
Switch
IN
OUT
STD. CAMERA
VP CAMERA
VIDEO
CAMERA
DC12V IN
RS232C
VP/STD Camera Selection Switch
RS232C Connector
< Switch Setting >
Remove the Upper Cover.
Set the switch SW3 on the board to the position as shown
below.
Set the VP/STD Camera Selection Switch on the rear
panel according to the camera.
Set to VP Camera position for VP Multiplexed Camera.
Set to STD Camera position for Standard Camera.
< Installing E.V.R. Adjustment Program >
Make a copy of following necessory files to your comput-
er from original floppy disk of the Remote E.V.R.
Adjustment Kit.
er from original floppy disk of the Remote E.V.R.
Adjustment Kit.
RADJ.EXE
CPR460E.SEQ
CPR460E.EVR
1. Confirm that the CONFIG.SYS file on your computer
contains DEVICE=ANSI.SYS.
2. Insert floppy disk containing E.V.R.adjustment program
into your floppy drive (for example,drive:A) and type A:
3. At the prompt, type CD IBMPC and press ENTER key.
4. Type COPY RADJ.EXE B: and press ENTER key.
5. Type CD\ and press ENTER key.
6. Type CD PAL and press ENTER key.
7. Type COPY CPR460E.SEQ B: and press ENTER key.
8. After completing installation of program, you are ready
to use the E.V.R. adjustment program.
<Rear>
<Front>
Board
SW3
ON
<SW3>
<SW3>
1
2
3
4
Select switch #2 to ON (PAL) or OFF (NTSC) position.
#
ON
OFF
1
FIX
2
PAL
NTSC
3
FIX
4
FIX
Click on the first or last page to see other WV-CPR460 / WV-CPR464E service manuals if exist.