WV-CPR460, WV-CPR464E - Panasonic Video Monitoring Service Manual Simplified (repair manual). Page 3

WV-CPR460 Series

– 1 –

Slide the panel to the left until it locks.

<WV-CPR460>

<WV-CPR464E>

q

e

w

r

t

y

o

!2

!3

u

!0

!1

i

!4

!5

!4

!8

!7

!5

!6

!6

Dynamic 

LOCK

Hi-Z-G/L 75

Ω

Hi-Z DATA TERM

4-LINE-2-LINE

VIDEO OUT

RS485

220-240V  ~  50Hz

T

R

G

A

B

B
A

GEN-LOCK

VIDEO OUT

RS485

AC 12V

IN

DC 12V

IN

GND

2

1

T

R

G

A

B

B
A

GEN-LOCK

q

Auto Iris Lens Connector
This connector is used to connect the auto iris lens with a 4-
pin male connector supplied as a standard accessory (Part
No.  YWM1943A).

w

e

Flange-back Adjusting Ring
This ring is used to adjust the back focal length or picture
focus.  Rotate this ring clockwise for a C-mount lens or
counterclockwise for a CS-mount lens.

r

t

Camera Mounting Screw Hole
This hole is used to mount the camera onto a mounting
bracket.

y

This button is used to move the cursor downward.  It is also
used to select items in the CAM SET UP menu.

u

This button is used to move the cursor to the left.  It also
selects the mode and can be used to adjust some levels.

i

This button is used to move the cursor upward.  It is also
used to select items in the CAM SET UP menu.

o

This button is used to move the cursor to the right.  It also
selects the mode and can be used to adjust some levels.

!0

This button is used to activate an item selected in the CAM
SET UP menu.

!1

Ω

Set this switch to Hi-Z when a gen-lock video input signal is
looped through.  In all other cases, set this switch to 75 

Ω

.

!2

RS-485 Termination Switch (Hi-Z DATA TERM)
This switch is used to terminate of the RS485 terminal.
Normally keep it DATA TERM position.

!3

Full-Duplex/Half-Duplex Selection Switches 
(4-LINE-2-LINE)
These triple switches are used to select either Full-duplex
(left side) or Half-duplex (right side) for the communication
lines.

!4

Gen-lock Input Connector (GEN-LOCK)
This connector is used to connect an external system for
synchronization.

!5

Video Output Connector (VIDEO OUT)
This connector is used to connect the VIDEO IN connector
of the monitor.

!6

RS485 Terminals 
(RS485, T(A)/T(B)/R(A)/R(B)/GND)
These terminals are used for RS-485 site communication.
Connect RS-485 cables to these terminals.

!7

AC Inlet Socket
This socket Is used to connect the power cord (supplied as
a standard accessory).

!8

AC/DC Compatible Input Terminal
(DC 12 V IN/AC 24 V IN)
This terminal Is for connecting the 12 V DC or 24 V AC
power supply cord.

Connect to 12 V DC (10.8 V-16 V) or 24 V AC
(19.5 V-28 V) class 2 power supply only.  Make
sure to connect the grounding lead to the GND
terminal when the power is supplied from a 24 V
AC power source.