Read JBL SUB 140P EMC - CB Certificate online
Page 14 of 75
TP10110019-ST
IEC/EN 60065
Clause
Requirement – Test
Result - Remark
Verdict
TRF No.: IECEN60065G
14
COMPONENTS
14.1
Resistors
a) Resistors between hazardous live parts and
accessible metal parts
accessible metal parts
No such resistor
N/A
b) Resistors, other than between hazardous live
parts and accessible parts
parts and accessible parts
N/A
Resistors separately approved .............................. :
N/A
14.2
Capacitors and RC units
Capacitors separately approved
P
14.2.1
Y capacitors tested to IEC 60384-14, 2
nd
edition .. : Y1-capacitor (CY3, CY4) and
Y2-capacitor (CY1, CY2)
complied with IEC 60384-14,
2nd edition
complied with IEC 60384-14,
2nd edition
P
14.2.2
X capacitors tested to IEC 60384-14, 2
nd
edition .. : X2-capacitor (CX1, CX2) is
complied with IEC 60384-14,
2nd edition
2nd edition
P
14.2.3
Capacitors operating at mains frequency but not
connected to the mains: tests for X2 ..................... :
connected to the mains: tests for X2 ..................... :
P
14.2.5
Capacitors with volume exceeding 1750 mm³,
where short-circuit current exceeds 0,2 A:
compliance with IEC 60384-1, 4.38 category B or
better ....................................................................... :
where short-circuit current exceeds 0,2 A:
compliance with IEC 60384-1, 4.38 category B or
better ....................................................................... :
C1 and C4
P
Capacitors with volume exceeding 1750 mm³,
mounted closer to a potential ignition source than
table 5 permits: compliance with IEC 60384-1,
4.38 category B or better ........................................ :
mounted closer to a potential ignition source than
table 5 permits: compliance with IEC 60384-1,
4.38 category B or better ........................................ :
N/A
Shielded by a barrier acc. to 20.1.4/table 21 or
metal ....................................................................... :
metal ....................................................................... :
metal enclosure is provided
P
14.3
Inductors and windings
Comply with IEC 61558-1, IEC 61558-2
(as relevant) and clause 20.1.4
(as relevant) and clause 20.1.4
N/A
Click on the first or last page to see other SUB 140P service manuals if exist.