Read JBL ON TIME 200ID (serv.man2) EMC - CB Certificate online
<12014165 001>
Page 16 of 73
IEC 60065
Clause
Requirement – Test
Result - Remark
Verdict
IEC60065E
ASTABEAB
14.3.4.3
Separating transformers with at least basic
insulation
insulation
Not such a transformer design.
N/A
14.3.5.1
Class II transformers have adequate insulation
between hazardous live parts and accessible parts
(double or reinforced insulation)
between hazardous live parts and accessible parts
(double or reinforced insulation)
See sub-clause 14.3.4.1 above.
P
Coil formers and partition walls = 0,4 mm
P
14.3.5.2
Class I transformers have adequate insulation
between hazardous live parts and accessible
conductive parts or those conductive parts or
protective screens connected to a protective earth
terminal
between hazardous live parts and accessible
conductive parts or those conductive parts or
protective screens connected to a protective earth
terminal
Not a class I transformer design.
N/A
Winding wires connected to protective earth have
adequate current-carrying capacity
adequate current-carrying capacity
N/A
14.4
High voltage components
N/A
High-voltage components and assemblies:
U > 4 kV (peak) separately approved
U > 4 kV (peak) separately approved
No component operating at voltage
exceeding 4kV.
exceeding 4kV.
N/A
Component meets category V-1 of IEC 60707
N/A
14.4.1
High voltage transformers and multipliers tested as
part of the submission
part of the submission
N/A
14.4.2
High voltage assemblies and other parts tested as
part of the submission
part of the submission
N/A
14.5
Protective devices
P
Protective devices used within their ratings
See sub-clause 14.5.2.1.
P
External clearances and creepage distances meet
requirement of clause 13 for the voltage across the
device when opened
requirement of clause 13 for the voltage across the
device when opened
(see appended table 13.3 and 13.4)
P
14.5.1.1
a) Thermal cut-outs separately approved
No thermal cut-outs provided.
N/A
b) Thermal cut-outs tested as part of the
submission
submission
N/A
14.5.1.2
a) Thermal links separately approved
No thermal link provided.
N/A
b) Thermal links tested as part of the submission
N/A
14.5.1.3
Thermal devices re-settable by soldering
No such components provided.
N/A
14.5.2.1
Fuse-links in the mains circuit according to IEC
60127
60127
Fuse link source complies with IEC
60127-2. For source details refer to
appended table 14.
60127-2. For source details refer to
appended table 14.
P
14.5.2.2
Correct marking of fuse-links adjacent to holder ... : Fuse marked on PCB adjacent to
component as: F1 T3,15AL250V.
P
Click on the first or last page to see other ON TIME 200ID (serv.man2) service manuals if exist.