ON STAGE (serv.man3) - JBL Audio EMC - CB Certificate (repair manual). Page 23

 

 

 

APPENDIX 

EN 60950:2000  

- Page 4 of 10 - 

 

 

   

 

Order No.  23171 

 

3.2.1 S  

(CH) 

Supply cords of equipment having a rated 

current not exceeding 10A shall be provided with 
a plug complying with SEV 1011 or IEC 60884-1 
and one of the following dimension sheets: 
- SEV 6532-2.1991 Plug type 15, 3P+N+PE 
250/400V, 10A  
- SEV 6533-2.1991 Plug type 11,  L+N  
250V, 10A  
- SEV 6534-2.1991 Plug type 12,  L+N+PE  
250V, 10A  
In general, EN 60 309 applies for plugs for 
currents exceeding 10A. However, a 16A plug and 
socket-outlet system is being introduced in 
Switzerland, the plugs of which are according to 
the following dimension sheets, published in 
February 1998: 
- SEV 5932-2:1998 Plug type 25, 3L+N+PE 
230/400V, 16A  
- SEV 5933-2:1998 Plug type 21, L+N+PE 
250V, 16A  
- SEV 5934-2:1998 Plug type 23, L+N+PE 
250V, 16A  

Class III equipment. 

3.2.1 S  

(DK) 

Supply cords of single-phase equipment 

having a rated current not exceeding 10 A shall be 
provided with a plug according to the Heavy 
Current Regulations Section 107-2-D1 

Class I equipment provided with socket-outlets 
with earth contacts or which are intended to be 
used in locations where protection aga inst indirect 
contact is required according to the wiring rules, 
shall be provided with a plug in accordance with 
standard sheet DK 2-1a or DK 2-5a

 

If poly-phase equipment and single-phase 
equipment having a rated current exceeding 10A 
is provided with a supply cord with a plug, this 
plug shall be in accordance with the Heavy 
Current Regulations Section 107-1-D1 or 
EN 60 309-2 

Class III equipment.