Read JBL ON STAGE (serv.man3) EMC - CB Certificate online
APPENDIX
EN 60950:2000
- Page 7 of 10 -
Order No. 23171
6.1.2.1 S
(NO, SE)
Add the following text between the first and
second paragraph:
If this insulation is solid, including insulation forming a
part of a component, it shall at least consist of either
part of a component, it shall at least consist of either
- two layers of thin sheet material, each of which shall
pass the electric strength test below, or
pass the electric strength test below, or
- one layer having a distance through insulation of at
least 0.4mm, which shall pass the electric strength test
below.
least 0.4mm, which shall pass the electric strength test
below.
If this insulation forms a part of a semiconductor
component e.g. an optocoupler, there is no distance
through insulation requirement for the insulation
consisting of an insulating compound completely filling
the casing, so that clearances and creepage distances
do not exist, if the component passes the electric
strength test in accordance with the compliance clause
below and in addition:
component e.g. an optocoupler, there is no distance
through insulation requirement for the insulation
consisting of an insulating compound completely filling
the casing, so that clearances and creepage distances
do not exist, if the component passes the electric
strength test in accordance with the compliance clause
below and in addition:
- passes the tests and inspection criteria of 2.10.8 with
an electric strength test of 1.5kV multiplied by 1.6 (the
electric strength test of 2.10.7 shall be performed using
1.5kV); and
an electric strength test of 1.5kV multiplied by 1.6 (the
electric strength test of 2.10.7 shall be performed using
1.5kV); and
- is subjected to routine testing for electric strength
during manufacturing, using a test voltage of 1.5kV.
during manufacturing, using a test voltage of 1.5kV.
It is permitted to bridge this insulation with a capacitor
complying with EN 132400:1994, subclass Y2
complying with EN 132400:1994, subclass Y2
No TNV circuits.
N
6.1.2.2 S
(FI, NO, SE)
The exclusions are applicable for
Permanently Connected Equipment and
Pluggable Equipment Type B only
Pluggable Equipment Type B only
No TNV circuits.
N
G.2 S
(NO)
Due to the IT power distribution system used
(see Annex V, figure V.7), the a.c. mains supply
voltage is considered to be equal to the line -to-line
voltage, and will remain at 230V in case of a
single earth fault
voltage is considered to be equal to the line -to-line
voltage, and will remain at 230V in case of a
single earth fault
Considered.
N
Annex H C
Replace the last paragraph of this annex by: At
any p oint 10cm from the surface of the operator
access area, the dose rate shall not exceed
1
any p oint 10cm from the surface of the operator
access area, the dose rate shall not exceed
1
µ
Sv/h (0.1 mR/h) (see note). Account is taken of
the background level.
The unit does not emit X-ray radiation.
N
Annex H C
Replace the note as follows: NOTE – These
values appear in Directive 96/29/Euratom
values appear in Directive 96/29/Euratom
The unit does not emit X-ray radiation.
N
Click on the first or last page to see other ON STAGE (serv.man3) service manuals if exist.