ON STAGE (serv.man3) - JBL Audio EMC - CB Certificate (repair manual)

on stage (serv.man3) emc - cb certificate
Model
ON STAGE (serv.man3)
Pages
55
Size
1.14 MB
Type
PDF
Document
EMC - CB Certificate
Brand
Device
Audio
File
on-stage-sm3.pdf
Date

Read JBL ON STAGE (serv.man3) EMC - CB Certificate online

 
 
 
 
- Page 1 of 19 - 
 
 
 
 
 
Order No.  23171 
 
TEST REPORT 
IEC 60950, 3rd Edition, 1999 
 
 
Product  
Computer Speaker system 
Name and address of the 
applicant 
 
Name and address of the 
manufacturer 
  
Name and address of the 
factory 
  
Harman (Suzhou) Electronics Co, LTD. 
3, Jinshan Road, 
Suzhou New District 
Jiangsu Province 
China, 215011 
Rating and principal 
characteristics 
1 A, 18 VDC 
SELV 
Class of equipment 
Class III equipment
 
Trade mark  
 
Model/type  
on stage 
Serial no  
Prototype 
Tested according to  
IEC 60950, 3rd Edition, 1999
 
 
Safety of information technology equipment 
Name and address of the 
testing laboratory 
 
11696 Sorrento Valley Road, suite F  
San Diego, CA  92121 USA 
Telephone 
+1 (858) 755-5525 
Fax 
+1 (858) 452-1810 
Tested by  
 
 
15 June 2004 
 
Signature  
Date 
  
Manuel E. Ugalde  
 
 
Name in block letters 
 
Verified by   
 
 
15 June 2004 
 
Signature
 
Date 
  
Grant Schmidbauer 
 
 
Name in block letters 
 
 
The content of this TRF fully covers the original TRF published by FIMKO. This form is only for use by Nemko, or by others 
according to special agreement with Nemko. The completed test report is not valid for external use, unless issued by Nemko or 
attached to a Nemko certification document. The report shall not be reproduced without written permission from Nemko and may 
then only be copied in full.  
Issue Nemko 2001-01 
 
 
 
 
- Page 2 of 19 - 
 
 
   
 
Order No.  23171 
 
 
Additional tests according to: 
 
Common Modifications, Special National Conditions and 
National Deviations   
EN 60950: 2000.  
Common Modifications, Special National Conditions 
and National Deviations. (See Appendix EN 60950: 
2000; confer countries indicated under additional 
information). 
Other requirements   
 
  
 
 
 
 
All country deviations listed in the CB Bulletin are 
covered by the Common Modifications, Special 
National Conditions, National Deviations, and National 
Requirements noted above except for the following 
countries which are documented in Country Deviation 
Appendix’s attached to this report: 
Australia (including New Zealand): CB Bulletin No. 
105A, dated May 2003. 
Canada: CB Bulletin No. 105A, dated May 2003. 
China: CB Bulletin No. 105A, dated May 2003. 
Israel: CB Bulletin No. 105A, dated May 2003. 
Japan: CB Bulletin No. 105A, dated May 2003. 
Republic of Korea: CB Bulletin No. 105A, dated May 
2003.  
Singapore: CB Bulletin No. SS2 37, dated 2001. 
United States: CB Bulletin No. 105A, dated May 2003. 
General remarks: 
The test results presented in this report relate only to the object tested. 
This report shall not be reproduced except in full without the written approval of the testing laboratory. 
 
Possible test case verdicts: 
P = Pass, F = Fail, = Not applicable, — = No verdict required.  Placed in the column to the right (Verdict).
 
 
 
 
 
 
- Page 3 of 19 - 
 
 
   
 
Order No.  23171 
 
 
 
SUMMARY OF TESTING : 
 
Sub -clause  
Information/Remarks 
Comments 
1.2.2.1
 
Normal load as described in Annex L or as close 
as possible to the most severe normal use.  
Normal operation is considered 1/8
th
 of maximum 
undistorted.  Non-clipping was determined using a 
1 KHz sinusoidal signal input.  For maximum 
normal operation, 1/8
th
 of the non-clipping 
amplitude was used with a filtered pink noise input 
signal. 
1.7.2 
Safety instructions, required markings regarding 
use of a specified power supply. 
Class III Equipment with an enclosure made of 
HB-Material, using a non-special connector for the 
DC input must have a marking stating the 
manufacturer and model number of the power 
supply to be used.  Marking is provided. 
1.7.12  
Language of safety markings/instruction. 
Instructions and equipment marking related to 
safety shall be applied in a language, which is 
acceptable in the country in which the equipment 
is to be sold. 
3.2 
Connection to the supply. 
Unit is powered by a limited power source  
complying with Sub-clause 2.11. The external 
power supply was not evaluated in this test report. 
 
 
 
 
 
- Page 4 of 19 - 
 
 
   
 
Order No.  23171 
 
 
ADDITIONAL INFORMATION
 
 
The subject equipment is a computer stereo system powered by a detachable Limited Power Source 
with a non-specialized type connector. 
 
Equipment mobility:  Moveable Equipment intended for tabletop use. 
 
Connection to the supply:   Class III equipment, not directly connected to mains. 
 
Circuit characteristics:  Secondary Circuits, powered by external Limited Power Source  
 
Weight:   0.5 kg. 
 
Dimensions:  171.0 mm diameter 38 mm tall 
 
Maximum recommended ambient (Tmra):  25°C  
 
 
 
NAME AND ADDRESS OF PRODUCTION-S ITES (FACTORIES):
 
 
See page 1. 
 
 
 
INFORMATION ABOUT THE STANDARDS / DOCUMENTS CONSIDERED 
 
 
IEC 60950, 3
rd 
Edition: 1999 
 
EN 60950, 3
rd
 Edition: 2000
 
 
 
Page of 55
Display

Download JBL ON STAGE (serv.man3) EMC - CB Certificate

Here you can read online and download JBL ON STAGE (serv.man3) EMC - CB Certificate in PDF. ON STAGE (serv.man3) emc - cb certificate will guide through the process and help you recover, restore, fix, disassemble and repair JBL ON STAGE (serv.man3) Audio. Information contained in service manuals typically includes schematics / circuit diagrams, wiring diagrams, block diagrams, printed wiring boards, exploded views, parts list, disassembly / assembly, pcb.